ページを読み込んでいます...
ページを読み込んでいます...
This product includes small and sharp edged parts. Always assemble and
keep this product out of chldren's reach.
Install only the specified batteries in the correct polarity. Never dissassemble
batteries as this may cause heat or damage and is dangerous.
Handle tools such as cutting knives, shears and screwdrivers etc. carefully.
Keep antenna point away from people's faces and do not wave around.
Do not touch spinning propellers. They can cause injury.
During and after operation, the motor and batteries will be hot.
Do not touch them until they have had time to cool down.
3
1
ページを読み込んでいます...
ページを読み込んでいます...
6
1
Continually monitor the charger while charging is in progress.
Operate and store the DC Peak Charger out of reach of children.
Some cars may not be able to be used as a power source.
(This product is designed specifically for use with 12V car batteries).
Always use the correct polarity (+ -) when connecting the DC Peak Charger's terminals and connectors.
Do NOT operate the DC Peak Charger in direct sunlight or in high temperatures.
When using the DC Peak Charger with a 12V car battery, turn the car's engine OFF first.
Never charge battery while engine or model are still running
(as the voltage changes prevent the auto-cut mechanism from working properly).
Do not use near flammable materials or plastics etc. that may ignite or deform from heat.
(Do not leave battery inside car when charging).
Avoid drops or severe shocks to the DC Peak Charger.
7
*
*Sharp Hobby Knife
* 3 8
*8 X AA Alkaline Batteries
Do not use any damaged batteries.
Damaged
*
*Phillips Screwdriver (L, S)
*
*Scissors
2
/ ITEMS INCLUDED
3
/ ADDITIONAL ITEMS REQUIRED
*
*Fuselage
*
*Main Wing
* 4
*Rubber Bands (4)
*
*Main Landing Gear
*3 x14 mm TP 1
*3 x14 mm TP Screw (1)
*8.4-600mAh
*8.4-600mAh Ni-MH Battery
*D
*DC Peak Charger
*3 x10 mm TP 4
*3 x10 mm TP Screw (4)
*2.5 x12 mm TP 2
*2.5 x12 mm TP Screw (2)
*4
*4-channel radio system
*
*Ribbon
For Japanese Market Only.
*
*Battery Hatch
*
*Hatch Stopper
*
*Decal
R
R
R
R
R
THE FINEST RADIO CONTROL MODELS
R
THE FINEST RADIO CONTROL MODELS
THE FINEST RADIO CONTROL MODELSTHE FINEST RADIO CONTROL MODELS
No.1xxxx PIPER CUB J3
KYOSHO PRINTED IN CHINA
THE FINEST RADIO CONTROL MODELS
8
/ Transmitter Functions
1
2
3
4
5
6
8
9
Transmitter
Turns model to left or right.
Adjusts throttle so motor will not move at neutral.
Controls propeller speed
4
/ GLOSSARY OF MAIN PARTS
For operating this model, use only the Transmitter
included. Do not use other transmitters.
Crystals are not changeable.
Battery Cover
Battery Level Indicator
Power Switch
Rudder Stick (Left/Right)
Throttle Stick (Up/Down)
7
Elevator Stick (Up/Down)
Steering Trim
Adjust up/down so plane flies horizontal
Adjust left/right so plane flies straight
Controls plane's upwards/downwards movement
Elevator Trim
Throttle Trim
Transmitter Antenna
1
3
4
5
2
7
6
8
9
4
9
Motor
Gear Reduction Unit
Battery Hatch
Main Gear
Receiver/Amp
Servo Horn
Servo Horn
Elevator Servo
Rudder Servo
Rudder Rod
Connector
Elevator Rod
Main Wing Strut (L)
Antenna
Main Wing Strut (R)
Rudder
Hatch Stopper
Horn
Elevator Rod
Rudder Rod
Elevator
Spinner
Propeller
/ Glossary of Main Parts
Crystals are not changeable.
10
4
/ Battery Charger Components
Connect to 12V car battery terminals for stable current (Note: Red is +, Black is -)
Current Adjuster
Charge Lamp
Charger Connector
Adaptor for charger
8.4V600mAh Ni-MH Battery
5
/ Assembly
/ Assembling the Airplane
1
T
H
E
F
I
N
E
S
T
R
A
D
I
O
C
O
N
T
R
O
L
MO
D
E
L
S
Apply excess decals to your liking.
Apply decals to both sides.
2
3 x10 mm
3 x10 mm TP
TP Screw
4
11
3
5
Battery Hatch
Hatch Stopper
2.5x12mm
4
Align to center.
Secure wing to fuselage with rubber bands as shown. Control will be impossible if wing becomes loose.
3 x14 mm TP
TP Screw
1
2
2.5 x12 mm TP
TP Screw
12
5
6
/ BEFORE OPERATING
/ Loading Battery
Battery Polarity Markings
Battery Cover
5
Approx. 45mm
CG
Antenna
Center of gravity is as per diagram.
ページを読み込んでいます...
14
2
6
Move Throttle Stick all the way down to confirm propeller stops
If propeller doesn't stop completely, adjust Throttle Trim accordingly
Move Throttle Stick up to confirm propeller starts spinning
<Elevator>
< >
<Propeller>
< >
<Rudder>
< >
/ Check Radio System
1
2
Loading Battery
Hatch Stopper
Battery Hatch
Always turn the transmitter's power switch ON first!
Keep a minimum of 10m away from anyone else using a transmitter.
Keep the area around the propeller clear in case it starts spinning.
Be extremely careful around a spinning propeller
15
/ Flight Conditions
1
The ideal location for flying has wide-open
space in four directions with no people.
(If using a model airfield, be sure to contact
the airfield's administrator for permission).
Choose Location Carefully Do NOT operate model near these areas
Do NOT use near: houses or buildings; children's play areas; road traffic; railways; airports; overhead
powerlines and pylons. Make sure no people, especially children, are nearby.
2
3
Fly in calm weather conditions with no winds or gentle winds (as indicated by the fluttering ribbon)
Strong
Wind
2~3m
Light Wind
7
/ Flight Manual
16
7
/ Pre-Flight Check
1 2
3
4
Always check that no one is using the same frequency
(band) in the same area!
5
Switch tranmitter ON and connect battery, and
advise any people nearby. Make sure there is no
one near the propeller.
Check for any bends or damaged parts
on main wing, fuselage or tail wing.
Check that propeller, adapter and
all screws are securely fastened!
Securely fasten the main wing with rubber bands.
ON
6
In case motor starts rotating accidentally, have
an assistant hold the rear part of the plane securely.
7
Check plane responds properly to control signals.
8
Extend transmitter antenna all the way, and test the range of the radio
signal.
Step back about 30 m and check for any unusual behaviour.
About 30 meters
ページを読み込んでいます...
ページを読み込んでいます...
ページを読み込んでいます...
20
7
Do not use with damaged or broken parts (may result in accidents or injury).
Please replace with new parts.
1
After-Flight Maintenance
/ Damaged Parts
When not flying, disconnect battery
connector and remove battery from
plane.
3
Remove any grime. Add grease to rotating parts.
2
For next flight, check that no screws have
loosened and replace any scratched or
damaged parts.
8
/ Trouble Shooting
/ Problem
/ Cause
/ Correction
Model doesn't move
Loss of Control
Doesn't Fly Straight
Propeller Doesn't Stop
Not Enough Power
R/C
13
12
13
Batteries have run down.
Throttle Trim is not adjusted correctly.
Rudder Trim is not adjusted correctly.
Main road or large steel pylon is nearby.
R/C model using same band (frequency) is nearby.
Antenna is missing or not attached properly.
There is not enough charge left in Transmitter batteries.
There is not enough charge left in Transmitter batteries.
Transmitter batteries are wrong type or wrong polarity.
Power switch on the Transmitter is not turned ON.
Batteries have run down.
Battery is not connected.
Batteries have run down.
Fly model in different area.
Change batteries as per Instruction Manual P.13.
13
Change batteries as per Instruction Manual P.13.
Check polarity and type as per Instruction Manual P.12.
Switch power on as per Instruction Manual P.13.
ページを読み込んでいます...
FOR JAPANESE MARKET ONLY.
FOR JAPANESE MARKET ONLY.
SPARE PARTS
OPTIONAL PARTS
No. Part Names
10221-01
10221-02
1
420
840
10221-03
10221-04
10221-05
Cowling
Main Gear Set
Decal
735
294
1260
210
Battery Cover Set
Gear Reduction Unit
No. Part Names Quantity
10221-17
RX unit for Piper J3 RTF.
(Band 17)
RX unit for Piper J3 RTF.
(Band 19)
RX unit for Piper J3 RTF.
(Band 21)
RX unit for Piper J3 RTF.
(Band 50)
RX unit for Piper J3 RTF.
(Band 52)
RX unit for Piper J3 RTF.
(Band 54)
J3/RTF
RX 17
10221-19
J3/RTF
RX 19
10221-21
J3/RTF
RX 21
10221-50
J3/RTF
RX 50
10221-52
J3/RTF
RX 52
10221-54
J3/RTF
RX 54
No. Part Names
71193 82592
90202
72102
72551
2625
36750
82591-40
82591-72
8.4V-600mAh Ni-MH Battery
Excel PRO Charger Ver 2.0
Multi Charger IV
5040
12600
12600
5ch Micro RS Set (40MHz) AFRS-14
5ch Micro RX Set (40MHz) AFR-14
5ch Micro RX Set (72MHz) AFR-17
5ch Micro RS Set (72MHz) AFRS-17
No. Part Names
82593-40
3360
6090
82593-72
8.5g Micro Servo AFS-1
6090
5040
Sky Victory 360P
90203
3990
Sky Victory 280P
This RX unit is exclusive for Piper J3 RTF. Do not use with other transmitter.
No.
Quantity
6
1
8 9
2
10
1
19
10221-06
10221-07
630
9870
9870
9870
9870
9870
9870
1575
10221-11
10221-12
10221-13
Propeller Set
Motor
Main Wing Set
3150
3150
2415
Fuselage
Tail Wing Set
1
1
1
2
1
4 5
2
20
x 1
22
x 2
23
x 1
22
x 2
23
x 1
22
x 2
23
x 1
22
x 2
23
x 1
22
x 2
23
x 1
22
x 2
23
2
7
4
3
2
8
1
12
1
16
13
3
14
1
15 17 18 21
1
11
210
210 210
22
/
