IB-200-X3LITE-00 说明书X3 Lite 英法西德意葡日等26国语言出口V1.0
材质：65g哑光铜板纸
工艺：85%灰印刷
尺寸：55x70mm
页面数及装订方式：x面 x 页，对折打钉
Reset
Charging
Controls
Note:
1. Images are for illustrative purposes only and may dier from the
actual product.
2. Download Edier Connect App for more customizable control settings.
Earbuds
1. When hearing a low batte prompt tone, please place
the earbuds in the case for charging.
2. Red LED on earbud is steady lit when charging and
o when fully charged.
Charging Case
1. Please connect the case to power source with the
included Type-C charging cable for charging.
2. Red LED is steady lit when charging and o when
fully charged.
Note:
Please do not charge the earbuds when there is sweat or
other liquids inside the charging po, which may damage
the earbuds.
Input: 5V 200mA(Earbuds)
5V 1A(Charging case)
1. Power ON when taken out of the case.
2. Power OFF when placed in the case.
EN
Power ON/OFF
Note:
If there is no Bluetooth connection for 10 minutes after power on, the
earbuds will turn o automatically.
1 2 3
Edier Connect
Edier Connect
App Store
Download on the
CN
開/關機
配對
首次配對
1. 從充電盒中取出耳機，白色和紅色
指示燈交替閃爍。
2. 在藍牙設備上搜索 “EDIFIER X3 Lite” 選擇連接，連接成功後，白色指示燈
5秒閃2次。
注意:
再次開機，耳機可自動回連最後一次連接過的設備。
左右耳連接
重置
充電
耳機充電
1. 耳機出現低電量提示音時，將耳機放入充電盒充電。
2. 充電時，耳機紅色指示燈常亮，充滿後熄滅。
充電盒充電
1. 請接入本產品包裝盒內附帶的Type-C充電線，連接電源
充電。
2. 充電時，充電盒紅色指示燈常亮，充滿後熄滅。
注意：
請勿在充電口有汗液或其他液體時對耳機進行充電，有可能
對耳機元器件造成損壞！
控制
注意：
1.本說明書中的圖片均為示意圖，可能與實物有偏差。
2.更多拓展功能可通過Edier Connect App來操作。
輸入: 5V 200mA(耳機)
5V 1A(充電盒)
注意:
耳機開機10分鐘後無藍牙連接，耳機自動關機。
xx xx xx
xx xx xx
1. 開蓋取出耳機開機。
2. 耳機放入充電盒中關機。
Manual
True Wireless In-Ear Headphones
X3 Lite
Model: EDF200131
Edier International Limited
P.O. Box 6264
General Post Oce
Hong Kong
www.edier.com
2023 Edier International Limited. All rights reseed.
Printed in China
NOTICE:
For the need of technical improvement and system upgrade,
information contained herein may be subject to change from time to
time without prior notice.
Products of EDIFIER will be customized for dierent applications.
Pictures and illustrations shown on this manual may be slightly
dierent from actual product.
If any dierence is found, the actual product prevails.
IB-200-X3LITE-00 V1.0
For more information, please visit our website:
www.edier.com
@Edier_Global @Edier_Global@Edierglobal
White LED lit for 1s
白燈長亮1秒
Pairing
Note
For subsequent use, the earbuds will automatically connect to the device
used last time.
1st Pairing
1. Taken out of the case. White and red
LEDs will blink alternately.
2. Select "EDIFIER X3 Lite" in your Bluetooth device setting to connect.
White LED will blink twice in 5 seconds when successfully.
Indicator Indicator
指示燈
1. 耳機開機無藍牙連接且無TWS連接狀態下，
分別五擊左右耳機觸控面板進入TWS配對
模式，此時白色指示燈慢閃，左右耳連接
成功後進入藍牙配對模式，白色和紅色指示燈交替閃爍。
2. 在藍牙設備上搜索 “EDIFIER X3 Lite” 選擇連接，連接成功後，白色指示燈
5秒閃2次。
1. Taken out of the case.
2. Disconnected to any Bluetooth device.
Press and hold the touch panel on either earbud for around 8s until
red LED blinks 6 times to clear the Bluetooth pairing records and turn
o. If the left and right earbuds are connected, the other side will clear
the Bluetooth pairing record and turn o either.
3. Placed back in the case and taken out of the case again.
4. Select "EDIFIER X3 Lite" in your Bluetooth device setting to connect.
White LED will blink twice in 5 seconds when successfully.
Left & Right connection
1. When earbuds are turned on and there
is no Bluetooth connection and TWS
connection, respectively tap the touch
panel 5 times on both earbuds until white LED blinks slowly to enter
TWS pairing mode. Once the left and right earbuds are
connected successfully, white and red LEDs will blink alternately to
enter Bluetooth pairing mode.
2. Select "EDIFIER X3 Lite" in your Bluetooth device setting to connect.
White LED will blink twice in 5 seconds when successfully.
x2x2
x2x2
x2x2
x3x3
2s2s
2s2s
Left Touch Panel Right Touch Panel
左觸控面板 右觸控面板
1. 從充電盒中取出耳機。
2. 無藍牙連接狀態下，長按任一耳機觸控面板約8秒至紅色指示燈快閃6次，
清除藍牙配對記錄並關機, 如果左右耳TWS有連接，另一邊也聯動清除
配對記錄並關機。
3. 將耳機放回充電盒後再取出耳機。
4. 在藍牙設備上搜索 “EDIFIER X3 Lite” 選擇連接，連接成功後，白色指示燈
5秒閃2次。
Indicator Indicator
Indicator
Indicator
Indicator
指示燈 指示燈
x5 x5
x5 x5
NCC聲明：
取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更
頻率、加大功率或變更原設計之特性及功能。低功率射頻器材之使用不得影響飛航
安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得
繼續使用。前述合法通信，指依電信管理法規定作業之無線電通信。低功率射頻器
材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
設備名稱 Equipment name：入耳式真無線耳機 型號 (型式) Type designation (Type)：EDF200131
限用物質及其化學符號
Restricted substances and its chemical symbols
單元 Unit 鉛
Lead
(Pb)
金屬零件
超出
0.1wt %
塑膠零件 ○
○
○
電 纜
電路板元件 ○
○
○
○
備註1.〝 超出0.1 wt %〞 及〝 超出0.01 wt %〞 係指限用物質之百分比含量超出百分比含量基準值。
Note 1 ：“Exceeding 0.1 wt %” and “exceeding 0.01 wt %” indicate that the percentage content of the
restricted substance exceeds the reference percentage value of presence condition.
備註2.〝○〞係指該項限用物質之百分比含量未超出百分比含量基準值。
Note 2 ： “○ ” indicates that the percentage content of the restricted substance does not exceed the
percentage of reference value of prese ce n
備註3.〝－〞係指該項限用物質為排除項目。
Note 3 ： The “−” indicates that the restricted substance corresponds to the exemption
汞
Mercu
(Hg)
○
○
○
○
鎘
Cadmium
(Cd)
○
○
○
○
多溴聯苯
Polybrominated
biphenyls
(PBB)
○
○
○
○
多溴二苯醚
Polybrominated
diphenyl ethers
(PBDE)
○
○
○
○
六價鉻
Hexavalent
chromium
(Cr )
+6
Input: 5V 200mA(Earbuds)
5V 1A(Charging case)
Declaration for EU
Frequency Band: 2400MHz - 2483.5MHz
RF Power Output: ≤13 dBm (EIRP)
There is no restriction of use.
FCC statement:
This device complies with Pa 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful inteerence, and (2) this device must
accept any inteerence received, including inteerence that may cause
undesired operation.
IC statement:CAN ICES-003(B) / NMB-003(B).
FCC ID: Z9G-EDF207
IC:10004A-EDF207
Hereby, Edier International Limited declares that the radio equipment
type EDF200131 is in compliance with Directive 2014/53/EU. The full text
of the EU declaration of conformity is available at the following internet
address:https://www.edier.com/int/eu-doc.html
XXX-XXXXXX
指示燈 指示燈
指示燈 指示燈
8s
8s
8s
8s
x2x2
x2x2
x2x2
x3x3
2s2s
2s
2s
產品中有害物質的名稱及含量
