EN
61/62/62T
Read First
Safety Information
WARNING
Understand and follow operating instructions carefully.Use
the meter only as specied in this manual; otherwise,the
protection provided by the meter may be impaired.
• When using test leads or probes, keep your fingers
behind the nger guards.
• Remove test lead from Meter before opening the battery
door or Meter case.
• Use the Meter only as specified in this manual or the
protection by the Meter might be impaired.
• Always use proper terminals, switch position, and range
for measurements.
• Never attempt a voltage measurement with the test lead
inserted into the A input terminal.
• Verify the Meter’s operation by measuring a known
voltage. If in doubt, have the Meter serviced.
• Do not apply more than the rated voltage, as marked on
Meter, between terminals or between any terminal and
earth ground.
• Do not attempt a current measurement when the open
voltage is above the fuse protection rating. Suspected open
circuit voltage can be checked with voltage function.
• Only replace the blown fuse with the proper rating as
specied in this manual.
• Use caution with voltages above 30 Vac rms, 42 Vac
peak, or 60 Vdc. These voltages pose a shock hazard.
• To avoid false readings that can lead to electric shock
and injury, replace battery as soon as low battery indicator
<appears.
• Disconnect circuit power and discharge all highvoltage
capacitors before testing resistance, continuity, diodes, or
capacitance.
• Do not use Meter around explosive gas or vapor.
• To reduce the risk of re or electric shock do not expose
this product to rain or moisture.
