Fodsports FX8 ユーザーマニュアル

HELMET BLUETOOTH INTERCOM

User Manual

FOCUS ON OUTDOOR SPORTS

1. Package Include ------------------------------------------------------------------------------------------------------------------- 2

2. Charging ----------------------------------------------------------------------------------------------------------------------------- 3

3. Installation & Disassembly ------------------------------------------------------------------------------------------------------ 4

4. Button and basic function operation ------------------------------------------------------------------------------------------ 7

5. Device Pairing -------------------------------------------------------------------------------------------------------------------- 11

6. Multi-device pairing connection ---------------------------------------------------------------------------------------------- 15

7. Technical Specifications ------------------------------------------------------------------------------------------------------- 19

8. Q&A / Warning -------------------------------------------------------------------------------------------------------------------- 20

9. Statement / Warranty/After-Sale Service ----------------------------------------------------------------------------------- 21

CONTENTS

1

1. Package Include

HELMET BLUETOOTH INTERCOM

User Manual

FOCUS ON OUTDOOR SPORTS

FX8 Headphone&Mic Kits

User Manual User Guide

Wired Microphone

Usb Cable Metal Clip EVA Booster 3M Glue Velcro

Hard Tube Microphone

Velcro

2.5mm to 3.5mm Cable

2

2. Charging:

Power cable insert

hole(socket)

2.1 The function button lights up red when charging, and the red light goes out after finishing

(As shown below). Please charge before using for the first time.

2.2 Please use a qualified charger 5V/1A±0.5A.

2.3 Please keep charging at least once every 2 months if the product is not used for a long time.

3

3.Installation & Disassembly

3.1 Speaker Installation

Remark: the microphone should be closed to and aim at the mouth as possible. The speakers are as close

to ears as possible. If installation position of the speaker is too deep so that the speaker is too far away from

the ear, the sponge in accessory may be used to jack up.

1.Open the inner helmet lining on

the ear position and attach the

velcro loops.

2.Attach the Headphone with

Velcro hook to the loop (the short

-line speaker is on the left).

3..Place Velcro on the right

position on the left side of the

helmet, match the microphone

with the mouth position, and tidy

up the cable and lining.

4

3.2 Fixed by clamp

1.Find and assemble the Unit base and metal clip.

3.Assemble the M1 S-PLUS: Insert the snap of the

bottom of the host in to the groove of the base,

press the host to the base so that the clip of the

base buckle the top of the host.

4.Insert the microphone plug , installation complete.

2.Fix the base on the right position.

5

3.3 Disassembly of the Device

1.Press the upper clamp buckle and move the

device upward to remove it.

2. Pull out the microphone plug.

Pull out

Slide up

6

4.Button and basic function operation

Switch On / OFF

Outlook / Button

Switch On: Long press Intercom button and Function button at the same time for 3 seconds,Voice

message will also say “ Welcome to FODSPORTS Bluetooth Communication System”.

Switch Off: Long press Intercom button and Function button at the same time for 3 seconds.Voice

message will also say “Power off ”.

LED Indicator

Function(Volume+/-)

Intercom

Headphone & Mic Kits

Aux In

MICRO-5Pin port ( charging / Data )

Reset

7

*For first time use,please recharge the device until the red light is off.

Power Detect & Notification Function

Cellphone

Low Power Notification: When power lower than 10%, red light flash in the function button and voice message

will remind power lower than 10%,please recharge immediately.

Voice Command

Answering Call: Short press Function button once.

Hangup Call: After call,short press Function button once.

Refuse Call: Long press Function button for 2 seconds.

Redial: Short press Function button twice.

Volume Up: Rotate the Function button forward while talking.

Volume Down: Rotate Function button Backward while talking.

Switch manual/automatic answering calls :While in standby, press and hold the intercom button , Previous

button and Next button at the same time for 3 seconds.

Power Detect Function: FX8 has power detect function,when device is on,short press Previous and Next button

at the same time,recorded voice message will tell you:

Power over 90%

Power over 50%

Power lower than 50%

Power lower than 10% please recharge immediately

8

*Cellphone must equipped with this function.*

FM Function

FM ON: When FM is off,Long press Next button for 3 seconds.

FM OFF: When FM is on,Long press Next button for 3 seconds.

Volume Up: Rotate the Function button forward.

Volume Down: Rotate the Function button backward.

Search Desk channels: When FM is on,short press Previous/Next button once.

Music Function

When your FX8 is paired up with cellphone,short press Previous button twice,will automatically switch on the

voice command function (only for iOS and Android ).

Play: When Standby,short press Function button once.

Pause: When music is playing,short press Function button once.

Volume Up: Rotate the Function button forward.

Volume Down: Rotate the Function button backward.

Play Previous: When music playing,short press Previous button once.

Play Next: When music playing,short press Next button once.

9

short press Previous button twice Automatically switch on voice command input function

*When device is in the state of crash or stuck, Long press [Reset] button 5 second to restart the system.

Memory Clear

Reset

Memory Clear: When device is on,press Function and Previous button at the same time for 5 seconds.Then

FX8 will clear the pairing memory with other devices.

Intercom Function

Switch Intercom On: When device on,short press Intercom button once.

Switch Intercom Off: When talking,short press Intercom button once.

Volume Up: When talking,Rotate the Function button forward.

Volume Down: When talking,Rotate the Function button backward.

10

Hold down for 5 seconds

5.Device Pairing

5.1 Pairing Modes

5.1.1 Passive pairing mode

5.1.2 Active search mode

When device is on,long press Function button to enter Pairing Mode,red and blue lights flash quickly,voice

notice “ pairing ”. Pairing mode for connection to Bluetooth devices such as mobile phones and Bluetooth

GPS.

11

Hold down

for 3 seconds

Hold down

for 3 seconds

5.2 (A) FX8 connect with (B) FX8

5.3 Pairing With Cellphone

A FX8 is on positive search mode(refer to 5.1.2), B FX8 is on passive search mode (refer to 5.1.1),A and B

FX8 change from flashing red and blue lights alternately to function and intercom buttons flashing blue lights

at the same time,connect successfully.

When device is on,long press Intercom button to enter Search Mode , red and blue lights flash slowly,

voicemessage says “ Searching ”.Search mode only use for intercom function connection between

FX8 devices.

12

Hold down

for 3 seconds

Intercom

5.4 Connect with two phones

STEP1.When device is on,long press Function button,red and blue light flash quickly, entering passive pairing

mode.(refer to 5.1.1)

STEP2.Turn on cellphone Bluetooth,Select“ FODSPORTS FX8”,the pairing is complete.Voice message will

notice “Device Connected”.

Select

FODSPORTS FX8

Step1 . Connect to the first phone(refer to 5.3)

Step2 . Long press the Function button, FX8 on passive search mode, connect to the second phone

(refer to 5.3)

13

5.5 Wire Connecting

Any device with 3.5mm connector can transmit voice signal to FX8.

When device wire connected by 2.5mm to 3.5mm cable to FX8,Complete the wired sound source input.

Press the [Previous] and [Next] buttons for 3 seconds to turn on or turn off the wired audio input.

You need to purchase a cable if you need a wired connection for Walkie-talkie equipment.

Radio

Long press the [Previous] and [Next] buttons for 3 seconds

GPS

Speed detector

Music player

Notice: FX8 can connect with two phones, but only support one phone for audio input.

14

Walkie-talkie

(No include)

6.Multi-device pairing connection

Step 1. A FX8 connect with B FX8(refer to 5.2) .

Step 2. Short press one time A or B intercom button to disconnet intercom .

Step 3. A connect with 2 phones(refer to 5.4) .

Step 4. A use 2.5 mm to 3.5 mm AUX audio line to connect with one audio device.

Step 5. B connect with one phone(bluetooth device) .

Step 6. Short press intercome button of A or B for connection.

6.1 Occasions: Rider A connect with Passenger B for intercom. Then A connect with two bluetooth devices

and one wired equipment and B connect with one bluetooth device(as shown below).

15

Notice: If A or B need to use the audio function of phone(bluetooth device), you need to disconnect the

intercom.

6.2 Multiple Intercom

6.2.1FX8 equipped with multiple intercom function,recommended 4 units(A,B,C,D), pairing procedure as

follow:

16

Active pairing mode

(flash slowly)

Passive pairing mode

(flash quickly)

Active pairing mode

(flash slowly)

Passive pairing mode

(flash quickly)

Step 1: Unit A is on positive search mode(refer to 5.1.2), Unit B is on passive search mode(refer to 5.1.1),

Unit A and Unit B change from flashing red and blue lights alternately to function button and intercom

button flashing blue lights at the same time,connect successfully.Short press the intercom button of Unit

B for one time, exit intercom state temporarily.

Step 2: Unit B is on positive search mode(refer to 5.1.2), Unit C is on passive search mode(refer to 5.1.1),

Unit B and Unit C change from flashing red and blue lights alternately to function button and intercom button

(flash quickly)flashing blue lights at the same time,connect successfully.Short press the intercom button of

Unit C for one time, exit intercom state temporarily.

Step 3: Unit C is on positive search mode(refer to5.1.2), UnitD is on passive search mode(refer to 5.1.1),

UnitC and Unit D change from flashing red and blue lights alternately to function button and intercom button

flashing blue lights at the same time,connect successfully.

Step 4: The intercom buttons and function buttons of Unit A ,B ,C and D flash blue light at the same time,

the connection of group intercom successfully.

17

Active pairing mode

(flash slowly)

Passive pairing mode

(flash quickly)

6.2.2 Memory Connection Function

FX8 will remember paired units,but after switch off and want to reconnect again,please follow the procedure:

*You can connect more FX8 by repeating the above methods.

*Intercom Interruption

In multiple intercoms mode,if there is an incoming call caused one unit away from the connection,after call,

will reconnected automatically.If interruption is caused by distance or bad signal,please press intercom button

to reconnect.

Notice: The first and the last one FX8 can connect with another 2 Bluetooth devices.The FX8 in the middle

connection position of the group can connect with an additional Bluetooth device.

For example: When in the group intercom mode, Unit B and C can only connect with one bluetooth device.

Unit A and D can connect with two bluetooth devices.

18

ページが読み込まれています...

Fodsports FX8 ユーザーマニュアル

Fodsports FX8 ユーザーマニュアル

他の言語で

関連論文

その他のドキュメント