Make sure that all parts are present before use.
Thank you for purchasing a “TIGER” Stainless Steel Mug.
Please read the instructions completely before use.
Keep these instructions for future reference.
MCB-H
MODEL
Instructions
Stainless Steel Mug
Safety Precautions
Safety Precautions
Do not use chlorine-based
bleaches or acetic acid
solutions when cleaning the
product.
Do not remove the protective
sheet on the underside of the
product.
Do not attempt to add any
beverages directly from the
spout.
Be sure to remove the entire
stopper before adding any
beverages.
Wipe off any liquid left around
the spout of the bottle after
drinking.
Keep the product in an upright
position at all times.
Important!
Keep out of reach of children.
Do not let children play with the
product.
Do not put dry ice or carbonated
beverages in the product.
Be sure to set the stopper in
proper position.
Do not open the lid when bottle
is tilted or near your face.
Drink slowly when drinking hot
beverages and be careful not to
tilt the product abruptly.
When using the product to
hold milk, dairy products, and
fruit juices, try to consume the
beverages within 6 hours.
Clean the product immediately
after use.
Noncompliance with these
instructions may result in scald
or injury.
Do not use the product if its
ability to retain heat declines.
Hot beverages can make the
product very hot, potentially
causing burns.
Do not place the product near
stoves, open flames, or other
sources of extreme heat.
Do not heat the product in a
microwave oven.
Do not fill the product above the
maximum level shown below.
Do not use the product for any
purpose other than keeping
warm or cold for drinking.
Do not knock over, drop or
expose the product to
excessive shocks.
Do not disassemble or attempt
to repair the product by
yourself.
Be sure to clean the product
immediately after use,
especially after consuming
sports drinks.
Do not store soups or beverages
containing salt in the product.
Do not leave the product in a
bag for a long time.
How to Clean
To keep your beverage warm or cool longer.
Pour hot (or cold) water into the body, and let it sit for one or two
minutes to allow the inside of the body to heat (or cool).
Discard the hot (or cold) water after preheating (or precooling).
The product rattles when shaken.
This is caused by a metal sheet moving inside the product that is used for boosting heat
retention.
Clean after every use.
Use mild kitchen detergent.
Use a sponge or soft cloth.
Be sure to clean the stopper and the gaskets after every use.
Attaching and Removing the gaskets
Be sure to wipe off with dry cloth.
Do not place in a dishwasher/dryer.
Specifications
Replacing and Purchasing
Consumable Parts Before contacting customer
service
The stopper and gaskets are consumable
parts. Check once a year for
damage/deterioration. If heavily stained or
loose, replace them.
For replacement parts, contact customer
service or the shop where you purchased
this product.
The utmost measures have been taken to
ensure the quality of this product.
However, should the product be defective,
contact your dealer and provide the
following information.
1. Product name
2. Model Number
3. Description of trouble
(As detailed as possible)
4. Purchase date
Feel free to send any questions or
comments about this product to the shop
where you purchased it.
For the purpose of performance improvement, designs, specifications and parts shown in this
publication are subject to change without notice.
123
MCB-H
TIGER HANBAI (H.K.) CO.,LTD.
Rm. 1006B, 10/FI., Join-in Hang Sing Centre, 71 - 75 Container Port Road,
Kwai Chung, N.T.
Tel: (852) 2418-0912 Fax: (852) 2418-0911
JAPAN TIGER CORPORATION OF U.S.A.
2730 Monterey Street, Suite 105 Torrance, CA 90503
Tel: (310) 787-1985 Fax: (310) 787-1986
EMAIL: [email protected]
TIGER CORPORATION
Head Office: 3-1 Hayamicho, Kadoma City, Osaka 571-8571, Japan
URL : http://www.tiger.jp/global.html
How to Use
How to Use
How to Clean
Capacity Heat retention Cold retention
0.36 liters / 12.2 oz Greater than 84°C •183°F (1hour)
Less than 8°C • 46°F (6hours)
Greater than 59°C •138°F (6hours)
0.48 liters / 16.2 oz Greater than 85°C •185°F (1hour)
Less than 7°C • 45°F (6hours)
Greater than 65°C •149°F (6hours)
When removing the gaskets, refer to the illustrations.
Attach the gaskets to the proper position and direction.
Lid gasket Stopper gasket
Lid Lid gasket
Protective sheet
Stopper
gasket
Spout
Body
Stopper
Maximum
level
Approx.
1cm•1/2-inch
Beverage
Lid gasket
Lid Stopper
Stopper
gasket
To remove To attach
Stopper
gasket
Flat
surface
Heat retention has been calculated under the condition of adding hot water at 95°C ±1°C •
203°F±2°F and leaving it in a room temperature of 20°C±2°C • 68°F±4°F for 1hour or 6hours.
Cold retention has been calculated under the condition of adding cold water at 4°C ±1°C • 39°F±2°F
and leaving it in a room temperature of 20°C±2°C • 68°F±4°F for 6hours.
Capacity is the actual volume of water that can be stored into the product when the stopper is
closed. This is not the “Maximum level” volume described in “Safety Precautions”.
Lid
Unlock
Push to open
the lid.
Safety
lock
Make sure that all parts are present before use.
Thank you for purchasing a “TIGER” Stainless Steel Mug.
Please read the instructions completely before use.
Keep these instructions for future reference.
MCB-H
MODEL
Instructions
Stainless Steel Mug
Safety Precautions
Safety Precautions
Do not use chlorine-based
bleaches or acetic acid
solutions when cleaning the
product.
Do not remove the protective
sheet on the underside of the
product.
Do not attempt to add any
beverages directly from the
spout.
Be sure to remove the entire
stopper before adding any
beverages.
Wipe off any liquid left around
the spout of the bottle after
drinking.
Keep the product in an upright
position at all times.
Important!
Keep out of reach of children.
Do not let children play with the
product.
Do not put dry ice or carbonated
beverages in the product.
Be sure to set the stopper in
proper position.
Do not open the lid when bottle
is tilted or near your face.
Drink slowly when drinking hot
beverages and be careful not to
tilt the product abruptly.
When using the product to
hold milk, dairy products, and
fruit juices, try to consume the
beverages within 6 hours.
Clean the product immediately
after use.
Noncompliance with these
instructions may result in scald
or injury.
Do not use the product if its
ability to retain heat declines.
Hot beverages can make the
product very hot, potentially
causing burns.
Do not place the product near
stoves, open flames, or other
sources of extreme heat.
Do not heat the product in a
microwave oven.
Do not fill the product above the
maximum level shown below.
Do not use the product for any
purpose other than keeping
warm or cold for drinking.
Do not knock over, drop or
expose the product to
excessive shocks.
Do not disassemble or attempt
to repair the product by
yourself.
Be sure to clean the product
immediately after use,
especially after consuming
sports drinks.
Do not store soups or beverages
containing salt in the product.
Do not leave the product in a
bag for a long time.
How to Clean
To keep your beverage warm or cool longer.
Pour hot (or cold) water into the body, and let it sit for one or two
minutes to allow the inside of the body to heat (or cool).
Discard the hot (or cold) water after preheating (or precooling).
The product rattles when shaken.
This is caused by a metal sheet moving inside the product that is used for boosting heat
retention.
Clean after every use.
Use mild kitchen detergent.
Use a sponge or soft cloth.
Be sure to clean the stopper and the gaskets after every use.
Attaching and Removing the gaskets
Be sure to wipe off with dry cloth.
Do not place in a dishwasher/dryer.
Specifications
Replacing and Purchasing
Consumable Parts Before contacting customer
service
The stopper and gaskets are consumable
parts. Check once a year for
damage/deterioration. If heavily stained or
loose, replace them.
For replacement parts, contact customer
service or the shop where you purchased
this product.
The utmost measures have been taken to
ensure the quality of this product.
However, should the product be defective,
contact your dealer and provide the
following information.
1. Product name
2. Model Number
3. Description of trouble
(As detailed as possible)
4. Purchase date
Feel free to send any questions or
comments about this product to the shop
where you purchased it.
For the purpose of performance improvement, designs, specifications and parts shown in this
publication are subject to change without notice.
123
MCB-H
TIGER HANBAI (H.K.) CO.,LTD.
Rm. 1006B, 10/FI., Join-in Hang Sing Centre, 71 - 75 Container Port Road,
Kwai Chung, N.T.
Tel: (852) 2418-0912 Fax: (852) 2418-0911
JAPAN TIGER CORPORATION OF U.S.A.
2730 Monterey Street, Suite 105 Torrance, CA 90503
Tel: (310) 787-1985 Fax: (310) 787-1986
EMAIL: [email protected]
TIGER CORPORATION
Head Office: 3-1 Hayamicho, Kadoma City, Osaka 571-8571, Japan
URL : http://www.tiger.jp/global.html
How to Use
How to Use
How to Clean
Capacity Heat retention Cold retention
0.36 liters / 12.2 oz Greater than 84°C •183°F (1hour)
Less than 8°C • 46°F (6hours)
Greater than 59°C •138°F (6hours)
0.48 liters / 16.2 oz Greater than 85°C •185°F (1hour)
Less than 7°C • 45°F (6hours)
Greater than 65°C •149°F (6hours)
When removing the gaskets, refer to the illustrations.
Attach the gaskets to the proper position and direction.
Lid gasket Stopper gasket
Lid Lid gasket
Protective sheet
Stopper
gasket
Spout
Body
Stopper
Maximum
level
Approx.
1cm•1/2-inch
Beverage
Lid gasket
Lid Stopper
Stopper
gasket
To remove To attach
Stopper
gasket
Flat
surface
Heat retention has been calculated under the condition of adding hot water at 95°C ±1°C •
203°F±2°F and leaving it in a room temperature of 20°C±2°C • 68°F±4°F for 1hour or 6hours.
Cold retention has been calculated under the condition of adding cold water at 4°C ±1°C • 39°F±2°F
and leaving it in a room temperature of 20°C±2°C • 68°F±4°F for 6hours.
Capacity is the actual volume of water that can be stored into the product when the stopper is
closed. This is not the “Maximum level” volume described in “Safety Precautions”.
Lid
Unlock
Push to open
the lid.
Safety
lock
MCB-H
123
MCB-H
TIGER CORPORATION
Head Office: 3-1 Hayamicho, Kadoma City, Osaka 571-8571, Japan
: http://www.tiger-corporation.tw
MCB-H
123
MCB-H
TIGER CORPORATION
Head Office: 3-1 Hayamicho, Kadoma City, Osaka 571-8571, Japan
: http://www.tiger-corporation.tw
/