Wearing the Earphones
The following are some suggested ways of wearing the earphones.
Over the ear
Inserting the Earphones
Insert the earphones so they form a tight seal. The fit of the earphone can greatly affect sound quality.
1/7©2017 Shure Incorporated
SE112-BT1
Shure Bluetooth Earphones
Important: If there seems to be a lack of low frequency response (bass), this means that the earphone sleeve is not forming a tight seal. Gently push the earphone
deeper into the ear canal or try a different sleeve.
Warning: Do not push the earphone sleeve beyond the ear canal opening.
Removing the Earphones
Grasp the body of earphone and gently twist to remove. Note: Do not pull on cable to remove earphone.
Changing Sleeves
• Twist and pull to remove the sleeve from the nozzle.
• Slide on a new sleeve so that it completely covers the barb and the
nozzle.
Caution: If the barb or any of the nozzle is exposed, the sleeve is not prop-
erly installed. Replace sleeves if they do not tightly grip the nozzle. To ensure
proper fit and performance, use only sleeves supplied by Shure (unless using
custom molded sleeves).
Shure Incorporated
SE112-BT1 Shure Bluetooth
®
Earphones
2017/11/272/7
Choosing a Sleeve
Soft flex sleeves are included in small, medium, and large sizes. Select an
earphone sleeve that provides the best fit and sound isolation. It should be
easy to insert, fit comfortably, and easy to remove.
Soft Flex Sleeves
Cleaning the Nozzle
If you notice a change in sound quality, remove the sleeve and check the nozzle of your earphone. If nozzle is blocked, clear obstruction by using wire loop end
of cleaning tool.
Nozzle Cleaning Tool
Nozzle
Warning: The cleaning tool is only to be used to clean the earphones. Any other use, such as using the tool to clean ears, could result in injury.
Shure Incorporated
SE112-BT1 Shure Bluetooth
®
Earphones
3/72017/11/27
Maintenance and Cleaning
Careful maintenance ensures a tight seal between the sleeve and nozzle, improving sound quality and product safety.
• Keep the earphones and sleeves as clean and dry as possible.
• To clean sleeves, remove them from earphones, gently rinse in warm water and air dry. Foam sleeves require a longer drying time. Inspect for damage and
replace if necessary. Ear sleeves must be completely dry before reusing.
• Wipe the earphones and sleeves with mild antiseptic to avoid infections. Do not use alcohol-based disinfectants.
• Do not expose earphones to extreme temperatures.
• Replace sleeves if they do not fit properly.
• Do not attempt to modify this product. Doing so will void the warranty and could result in personal injury and/or product failure.
Bluetooth
®
Earphones
Bluetooth
®
Pairing
1. Turn off the earphones. Press and hold center button on earphone remote
until the LED flashes blue and red.
2. From your audio source, select "Shure BT1."
3. LED turns blue when successfully paired.
For additional pairing options, please visit http://www.shure.com/earphones.
Charging the Earphones
Red LED indicates low battery.
1. Connect earphones to charging device using supplied cable.
2. LED is red while charging.
3. When earphones are charged, LED turns off.
Warning: Before charging, make sure the product is at room temperature,
between 0 to 45°C (32 to 113°F).
Note: Use this product only with an agency approved power supply which
meets local regulatory requirements (e.g., UL, CSA, VDE, CCC, INMETRO).
Using the Remote
The Center Button
Press and holdPower on
Press and hold, 5 secondsPower off
Press and hold, 10 secondsBluetooth pair
Click oncePlay/Pause
Click onceAnswer/End a call
Press and hold, 3 secondsDecline a call
Phone on, press and hold, 3 secondsActivate voice assistant
Up and Down Buttons
Click + or -Volume Up/Down
Press and hold +, 3 secondsNext track
Press and hold -, 3 secondsPrevious track
Shure Incorporated
SE112-BT1 Shure Bluetooth
®
Earphones
2017/11/274/7
Your phone may not be compatible with some functions. Visit
http://www.shure.com/earphones for more information.
Safety Information
Visit http://www.shure.com/earphones for the latest regulatory and compliance
information.
WARNING
• Follow instructions from manufacturer.
• Product battery may explode or release toxic materials. Risk of fire or
burns. Do not open, crush, modify, disassemble, heat above 140°F
(60°C), or incinerate.
• Attention should be drawn to the environmental aspects of battery dis-
posal.
• Product shall not be exposed to excessive heat such as sunshine, fire,
or the like.
• Do NOT make unauthorized alterations to this product.
WARNING:This product contains a chemical known to the State of California
to cause cancer and birth defects or other reproductive harm.
Note:Battery replacement to be performed only by Shure authorized service
personnel.
CAUTION: Follow applicable laws regarding mobile phone and headphone
use while driving.
This product contains magnetic material. Consult your physician on whether
this might affect your implantable medical device.
Accessories
For information about earphone accessories and other Shure products visit:
www.shure.com
Furnished accessories subject to change.
Information to the user
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC Part 15.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation of this device is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent
appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes
: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est sus-
ceptible d'en compromettre le fonctionnement.
Note: Testing is based on the use of supplied and recommended cable types. The use of other than shielded (screened) cable types may degrade EMC perfor-
mance.
Este equipo ha sido diseñado para operar con las antenas que enseguida se enlistan y para una ganancia máxima de antena de [+2.13] dBi. El uso con este
equipo de antenas no incluidas en esta lista o que tengan una ganancia mayor que [+2.13] dBi quedan prohibidas. La impedancia requerida de la antena es
de [50] ohms.
RMCE-BT1: IFT: RCPSHRM17-1234
SE112-BT1: IFT: RCPSHRM17-1234-A1
1. 經審驗合格之射頻電信終端設備，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
2. 射頻電信終端設備之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。所謂合法通信，係指依
電信法規定作業之無線電信。
3. 輸入、製造射頻電信終端設備之公司、商號或其使用者違反本辦法規定，擅自使用或變更無線電頻率、電功率者，除依電信法規定處罰外，國家通訊傳播委
員會並得撤銷其審驗合格證明。
4. 減少電磁波影響，請妥適使用
Shure Incorporated
SE112-BT1 Shure Bluetooth
®
Earphones
5/72017/11/27
運用に際しての注意
この機器の使用周波数帯では、電子レンジ等の産業・科学・医療用機器のほか工場の製造ライン等で使用されている移動体識別用の構内無線局（免許を要す
る無線局）及び特定小電力無線局（免許を要しない無線局）並びにアマチュア無線局（免許を要する無線局）が運用されています。
1. この機器を使用する前に、近くで移動体識別用の構内無線局及び特定小電力無線局並びにアマ チュア無線局が運用されていないことを確認して下さい。
2. 万一、この機器から移動体識別用の構内無線局に対して有害な電波干渉の事例が発生した場合には、 速やかに使用周波数を変更するか又は電波の発射を
停止した上、下記連絡先にご連絡頂き、混 信回避のための処置等（例えば、パーティションの設置など）についてご相談して下さい。
3. その他、この機器から移動体識別用の特定小電力無線局あるいはアマチュア無線局に対して有害な電波干渉の事例が発生した場合など何かお困りのこと
が起きたときは、保証書に記載の販売代 理店または購入店へお問い合わせください。代理店および販売店情報は Shure 日本語ウェブサイト
http://www.shure.co.jp でもご覧いただけます。
現品表示記号について
現品表示記号は、以下のことを表しています。 この無線機器は 2.4GHz 帯の電波を使用し、変調方式は「FH-SS」方式、想定与干渉距離は 10m です。
2,400MHz～2,483.5MHz の全帯域を使用し、移動体識別装置の帯域を回避することはできません。
Japanese Radio Law and Japanese Telecommunications Business Law Compliance. This device is granted pursuant to the Japanese Radio Law (電波法) and
the Japanese Telecommunications Business Law (電気通信事業法). This device should not be modified (otherwise the granted designation number will become
invalid).
Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não
pode causar interferência a sistemas operando em carater primario” Este produto está homologado pela ANATEL, de acordo com os procedimentos regulamen-
tados pela Resolução 242/2000, e atende aos requisitos técnicos aplicados. Para maiores informações, consulte o site da ANATEL - http://www.anatel.gov.br
Tel: 02-734-0653
Service Center contact information:
Battery Manufacturer/Country of Origin:
Dongguan Golden CEL Battery Co., Ltd / China
A/S
Rating: 3.7 Vdc, 110 mA
(401230) Product name (model name):
Battery safety certificate number: XU100702-16005A
Tel: 02-734-0653
5Vdc, 0.5mA
Shure Incorporated / China
SE112-BT1, RMCE-BT1
Shure Incorporated
TRA REGISTERED No: ER56780/17
DEALER No: 67442/17
The Bluetooth
®
word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Shure Incorporated is under
license. Other trademarks and trade names are those of their respective owners.
Environmentally friendly disposal
Old electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at the communal collecting
point via private persons is for free. The owner of old appliances is responsible to bring the appliances to these collecting points or to similar collection points.
With this little personal effort, you contribute to recycle valuable raw materials and the treatment of toxic substances.
Certifications
This product meets the Essential Requirements of all relevant European di-
rectives and is eligible for CE marking.
Hereby, Shure Incorporated declares that the radio equipment is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity
Shure Incorporated
SE112-BT1 Shure Bluetooth
®
Earphones
2017/11/276/7
is available at the following internet address: http://www.shure.com/eu-
rope/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: [email protected]
Specifications
Antenna Type
Chip
Antenna Gain
+2.13 dBi
Bluetooth 4.1
Frequency
2402 to 2480 MHz
Modulation Type
FHSS
RF Output Power
+5.38 dBm (E.I.R.P)
Shure Incorporated
SE112-BT1 Shure Bluetooth
®
Earphones
7/7
Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA Phone: +1-847-600-2000 Email: info@shure.com
/