4
0.5 mm
1.0 mm
243-0034 153
046-229-4115
()10001800
(0.5,1.0mm/2Pcs/M3)
Before beginning assembly, please read these instructions thoroughly!
Thank you for purchasing this product. Before installation, please carefully read and follow the instructions on this sheet in conjunction with the
instruction manual of the EVOLVA M3
Effect : This product lowers the upper suspension shaft by 0.5mm from the standard position and provides a wider set up range of the amount of
camber variation of the front suspension.
Carbon Front Upper Mount Plate
None
Height of upper suspension shaft
0.5mm lower than standard
0.5mm higher than standard
Same as standard height
Tighten a
screw lightly.
INSTRUCTION SHEET
No.FMW607
SP Front Upper Sus.Mount Set (EVOLVA M3)
© Copyright 2008 KYOSHO CORPORATION /
*SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
60950804-1 PRINTED IN JAPAN
FMW607-T01
www.kyosho.com
Carbon Front Upper Mount Plate(0.5,1.0mm/2Pcs/M3)
1575
FMW608
4
3 x 3mm
3 x 3mm
4 x 4mm
3 x 10mm
3 x 10mm
3 x 10mm
Set Screw
< Left >
< Right >
Button Head Cap Screw
Symbols used throughout
the instruction sheet.
Must be purchased separately!
Apply threadlocker (screw cement).
/