SOLDERING IRON with BOOSTER
Precautions
1. Do not use if a cut or damage is found on
power cord.
2. Do not supply higher than rated voltage.
3. Do not use near flammable or combustible
materials.
Warning
How to solder
H-600-230
1 Remove dirt, rust, oil, and oxidation films from
soldering point prior to soldering. Wiping
surface of area to be soldered with flux remover
etc., prior to soldering is also recommended.
2 Heat the spot to be soldered to solder melting
temperature (230 260 degrees C).
3 Apply solder to the junction of the soldering iron
tip and the item to be soldered.
4 If solder balls up and does not stick, tip is too
hot or an oxidation film has soiled the surface.
Clean the tip, allow to cool to room temperature
and begin again.
5 When the melted solder flows on the area,
remove the soldering iron, and inspect the
hardened solder to assure a good connection.
6 To avoid oxidization of the solder-plated area of
the tip, coat that area with melted new solder
after use, then switch off.
7 It is recommended to wash the soldered area
with flux remover and such after finished
soldering.
19W(130W )
19W(130W when boosting)
Power consumption
Maximum
temperature 410
1. Use a soldering iron stand.
2. Do not apply a physical shock.
3. Do not attempt to cool with water or any other
liquid.
4. Use only genuine tips and heaters.
5. Do not press the booster switch continuously
for more 30 seconds.
Caution
Replacing tip
Replacing heater
Use genuine tips and heaters.
The tip is covered with lead-
free solder which is easily
burned and stuck if heated with-
out using even for a short time.
Tin with solder when energize
for the first time.
Turn off the power after
wipe the used solder and
tin with new solder.
APPLICABLE
For
LEAD-FREE SOLDER
/
