P. 1 4
Troubleshooting
Possible Cause
- Power not turned on
- Controls are incorrectly set
- Household fuse has blown or power
supply is off
- Light bulb blows out or loose in socket
- Household fuse has blown
- Foil or trays lining on bottom of oven
- Household fuse has blown
- Reduce amount of water used in
cooking (Some condensation is
normal )
- Stirrup not engaged properly
- Discoloration of heating elements and
trimming is normal
Problem
Oven or grill not working
Lighting not working
Oven not heating up enough
Oven not working
Condensation building up
Door cannot be replaced after
removal
Solid heating element has been
discolored
Note: If the fuse continues to blow, contact
technician for a replacement
Note: If the fuse continues to blow, contact
technician for a replacement
Note: If the fuse continues to blow, contact
technician for a replacement
P. 13
Notes About Cleaning
1. Slide out baking pan and grill racks towards you until they reach the end.
2. Pull and lift them out.
3. Tilt up baking pan and grill racks at the front to the side supports. Be careful not to spill the contents.
4. Wash pan and racks with warm soap water.
5. Reverse the above steps to put the pan and racks back. Make sure they are placed between
2 support wires.
Removing Baking Pans & Grill Racks
Ⅲ.
1. Grasp the rack supports at the front.
2. Pull them firmly inwards.
3. To install the rack supports, first insert the rear hook to the rear hole.
4. Locate the front peg into the front hole and push in firmly.
Note: Rack support wires should be on top
Removing Side Rack
Ⅳ.
1. Hold fan cover by the two sides and pull towards yourself.
2. Insert the two tabs at the bottom of the fan into their corresponding holes.
3. Push the top back.
Note: The fan baffle must be replaced after cleaning.
Removing & Re-positioning Fan
Ⅴ.
Removing & Re-positioning Lighting
Ⅵ.
1. Turn lighting glass anti-clockwise and remove it for bulb replacement.
2. To remove side light, place a spoon under the light glass and lever off. Replace bulb and snap glass.
Follow the following steps to get better access to the oven interior for cleaning:
Note: Make sure power is connected when removing or positioning any parts.
1. Rotate the two stirrups forward so that they are engaged together onto the hooks on the hinge arms.
2. Hold both stirrups in place and slightly close the door. The stirrups will now remain engaged.
3. Close the door half way and lift it away from the oven.
4. Do not lift the door by the handle. Keep one hand on either side of the door
(Keep fingers away from the hinge arms).
Removing Oven Door
Ⅰ.
Positioning Oven Door
Ⅱ.
1. Position both hinge arms at the same time into the front.
2. Ensure that the location notches on the bottom of the hinge arms are positioned onto the
lower cutout lip.
3. Close the door partially to ensure that the location notch drops into place.
4. When the hinges are located, open the door fully and ensure the stirrups are disengaged.
Caustion:
- Do not use force and always ensure that the location notch is correctly engaged before
you operate the door
- Do not lift or carry oven door by the handle when removing or positioning
- Do not immerse oven door in water