Lubricate the hinge and the moving parts
periodically to prevent wear and prolong their life
span. Wear of the moving parts could cause an
incomplete crimp.
Precautions
1. Do not use on energized places.
2. Do not take apart or not re-model the ratchet
mechanism.
Warning
Daily care
1. Do not use for other than specified.
2. Carry out periodic inspection to prevent
incomplete crimp.
Caution
The ratchet mechanism does not allow the
handles to release unless crimping is
completed.
JQ 0607019
JIS C 9711 LT
CRIMPING TOOL P-75
Nominal sizes 1.25/2.0/5.5/8.0 are indicated on
the cavities. Other sizes except above are not
suitable to crimp. Terminal or sleeve and wire
should be crimped by following combinations.
Operation
Stranded
(mm2)
Cavity
(mm2)Single
(mm )AWG
No.
0.25-1.65 0.57-1.44
1.04-2.63 1.14-1.82
1.25
2.0
5.5
8.0 2.63-6.64
6.64-10.52 2.89-3.65
1.82-2.89
22-16
16-14
12-10
8
1 Squeeze the handles until they are opened
automatically to release the ratchet mechanism.
2 Put a terminal or a sleeve in the cavity of the
tool and squeeze the handles a little to hold the
terminal.
3 Insert the stripped wire into the terminal or the
sleeve.
4 Squeeze the handles until the ratchet becomes
free.
5 After crimping completion, the cavity No. is
embossed on the terminal. Make sure the No.
/
