Sanyo VC-0550 ユーザーマニュアル

タイプ
ユーザーマニュアル
VC-0550
Instruction Manual
Dummy Camera
Model VC-0550
1AC6P1P3310--
L9ZZP/WA (0408KR-HS)
1
1
SANYO Electric Co., Ltd.
Printed in China
For proper use, it is recommended to first carefully read these instructions.
This device is used as a dummy camera.
CAUTION
This mark indicates instructions that if neglected may lead to personal
injury or property damage.
(Specifications)
¡ (Weight) (Approx. 0.5 lbs.)
¡ (Dimensions)
120 mm (4.7")
99.8 mm (3.9")
103.5 mm (4.1")
Pushing the base plate lock (A), open the base plate in the arrowed direction.
Pushing the spot (C) of the dome cover cabinet on the opposite side of the rib mark (B),
open the cabinet in the direction of an arrow.
Set the base plate on the ceiling and tighten it securely using suitable screws and
washers (B).
(D)
¡ (Length) 35.0 mm (1.4" or more)
¡ (Diameter) 3.5 mm 5.0 mm (0.1" – 0.2")
¡ 5.0 mm
(Height of screw head, washer included: 0.2" or less)
Make sure to tighten the screws properly.
Using screws of sizes other than specified may cause the
unit to fall.
Memo: Note that the location of Sanyo’s logo is indicated by
the direction of the arrow (0617-A) attached on the
base plate.
3
(C)
(B)
2
(A)
1
Installation method
Place the notch of the base plate onto the rib (E) and hook (F) of the cabinet, and slide
the cabinet in the direction of an arrow until you hear it click, and then fix the base plate
and the cabinet securely using the supplied screws (G).
Set the rib mark (H) in place and push the dome cover in the direction of an arrow until
you hear it click.
(H)
5
(E)
(F)
(G)
4
¡
¡
CAUTION
¡Check that the installation location is strong enough to bear the camera before proceeding. Install to a
ceiling with no unevenness in its surface.
¡Waterproof the ceiling hole properly when installing the camera on the ceiling.
  • Page 1 1
  • Page 2 2

Sanyo VC-0550 ユーザーマニュアル

タイプ
ユーザーマニュアル

他の言語で