VC-0450
Instruction Manual
Dummy Camera
Model VC-0450
Printed on recycled paper
1AC6P1P3224--
L9ZZN/WA (0507KR-SY)
1
1
SANYO Electric Co., Ltd.
Printed in Japan
For proper use, it is recommended to first carefully read these instructions.
This device is used as a dummy camera.
CAUTION
This mark indicates instructions that if neglected may lead to
personal injury or property damage.
(Specifications)
¡ (Weight) (Approx. 370 g/0.8 lbs.)
¡ (Dimensions)
151 mm/6.0"
100 mm/4.0"
116 mm/4.6"
Pushing the base plate lock (A), open the base plate in the arrowed direction.
Set the base plate on the ceiling and tighten it securely using suitable screws and
washers (B).
¡ (Length) 35.0 mm/1.4" or more
¡ (Diameter) 3.5 mm/0.1" 5.0 mm/0.2"
¡
(Height of screw head, washer included): 5.0 mm/0.2" or less
Make sure to tighten the screws properly.
Using screws of sizes other than specified may cause the
unit to fall.
(B)
(B)
2
(A)
1
Installation method
¡
Aligning the ribs (C) and hook (D) on the camera unit with the slot on the base plate,
push the camera unit until it clicks.
¡Make sure that the camera unit and base plate fit perfectly.
(C)
(D)
3
¡
¡
¡
CAUTION
¡Check that the installation location is strong enough to bear the camera before proceeding. Install to a
ceiling with no unevenness in its surface.
¡Waterproof the ceiling hole properly when installing the camera on the ceiling.
¡Do not touch the camera after installation.
/