Part number (name) of replacement part
Main footAuxiliary FootProtective cap
[Shelf state]
[Container state]
Locking Unit Sliding pinGrip
Handle detail:
PartsContents
Thank you for purchasing this Snow Peak product. This product is a storage container that can be easily transformed into shelving. In order to ensure your safety when using this product, please read the following
instructions carefully before use. Please be sure to keep this document for future reference. If there is an item in the instructions that you do not understand, or if you find a fault in the product, stop use immediately
and consult the store where you purchased this product or contact our User Service department.
Stacking Shelf Container 25 / 50
UG-025G / UG-055G
Instruction Manual : Ver 2.01
Instruction manual ×1
(this document)
Main Unit ×1
CAUTION: Misuse could result in injury to the user and/or damage to property.
●Ensure that your fingers, clothing, etc. do not get pinched in the movable components of the container, particularly when transforming from one state to the other. • Impact with this product and another
person or property (vehicles, walls, etc.) may personal injury or property damage. ●When placing a box on the ground or stacking it on top of another box, place it down gently and reduce any sudden impact.
Ensure it is firmly in contact and secure prior to removing your hands. If it falls, the box could cause personal injury as well as damage to poperty and/or the product itself. ●This product uses steel plates.
Although the edges have been treated, handle with care. ●Although this product is made of rust-proofed steel plates, areas that have been damaged or edges that have seen sufficient wear may rust over
time. If you are storing items in the shelf containers for extended periods of time, rust from the product may transfer to the objects inside (or vice versa). Prevent direct contact between items that rust easily
and the shelf containers. ●Leaving this product in the rain or washing it with water will accelerate rusting. (increase the likelyhood and rate of rust formation. ●Remove all contents from the container before
transforming it from one state to another. Opening or closing a box while loaded may damage both the container and its contents. The weight of the contents may also cause the box to open or close once
unlocked, which could cause personal injury as well as damage to poperty and/or the product itself. ●As intense impact to the main feet may damage them, occasionally inspect them for cracks or other
abnormalities and replace the feet if any are discovered (refer to the Maintenance section for details). ●The scrivets that hold the main feet in place may be pushed out due to vibration or contact with the
load from the inside. If a scrivet is pushed out from the inside, gently push in the head of the scrivet with a Phillips screwdriver groove.
Safety precautions (Before use, please read this manual thoroughly to ensure safety and avoid accidents.)
DANGER: Misuse could easily result in a serious accident or death.
●When loading this product into a vehicle, the box must be in its container state.
●Ensure that stacked boxes do not obstruct the rear or side windows while driving.
●Ensure that the boxes and their contents do not fall out of the vehicle while it is moving.
●Keep the boxes unstacked and level if driving on bumpy roads. Otherwise, they may become damaged or tip over.
●These instructions aside, please observe all traffic laws.
WARNING: Misuse could result in serious injury or death.
●Before using the product, check each part for abnormalities. If there are abnormalities, take the product for inspection or repair by the dealer where the product was sold or Snow Peak
Customer Service.
●Only carry this product one at a time in the container state. If carried while stacked, they may obstruct your view or fall. If carried while in its shelf state, the contents are more likely to fall out.
●Before lifting the container, ensure that it is properly locked to prevent the box from opening while being carried.
●When boxes are stacked (in either the shelf or container state), do not lean on or shake them. Pay particlarly close attention to children, in the case that they try to hang or climb on the boxes,
etc. as the containers could tip or fall potentially causing serious injury or death.
●When stacking boxes are in their shelf state, place them on a flat surface in a sufficiently spacious and safe area. External factors, such as an earthquake, could cause stacked boxes to tip over,
leading to personal injury or property damage.
●To prevent the shelf containers from tipping over and becoming a safety hazard, avoid using this product on sloped ground or an unstable area. After setting up the product, ensure that it does
not wobble before use.
●Strictly observe the maximum load weight (20kg per box) and maximum stacked unit limit (3 stacked units, whether in shelf or a container state). Exceeding these limits may compromise the
safety and structural integrity of the product
●When picking up boxes that have contents in them, take sufficient care to avoid personal injury.
●Store the boxes out of direct sunlight and away from sources of heat as they may heat up and potentially cause burns.
Maintenance
●The main feet may be damaged due to strong impact or aging. If you discover that the main feet are damaged, cracked, or have any other abnormalities,
contact our User Service department to order UG-025G-001 (SHELF CONTAINER FOOT PARTS SET) or to request repairs/replacement.
●Store out of direct sunlight in a well-ventilated area with little humidity.
●The scrivets that hold the main feet in place may be pushed out due to vibration or contact with the load from the inside. If a scrivet is pushed out from the
inside, gently push in the head of the scrivet with a Phillips screwdriver groove.
●If light grime or water gets on this product, promptly wipe with a dry cloth and allow it to sufficiently dry.
●If salt (seasoning, etc.) or other chemicals get on this product, wipe thoroughly with a well-wrung cloth and allow it to sufficiently dry.
Specification
44.1lbs (20kg) each
Up to 3 units
12.8×20.5×8.25in
(325×520×210mm)
11. 5×16×7.7 i n
(290×405×195mm)
7.9lbs (3.6kg)
14.5×19.7×10in
(370×500×255mm)
12.1lbs (5.5kg)
16×24.5×10.6in
(405×625×270mm)
Materials
Maximum
number of
stacked units
Maximum
load weight
Stacking Shelf Container 25 Stacking Shelf Container 50
Main Unit: Stainless Steel
Handles: Bamboo, Stainless steel
Feet: Polycarbonate
Size
Interior
dimensions
Weight
Box
Handle
Scrivet
※Main and auxiliary feet are consumable items. If any abnormality such as damage or cracks are found,
Please contact our User Service to order the following products or to request repairs/replacement.
XUG-025G-01
Foot Part L SET(with scrivet × 1) for both
UG-025G/UG-055G
XUG-025G-02
Foot Part R SET(with scrivet × 1) or both
UG-025G/UG-055G
XUG-025G-03
Scrivets 2pcs sets