Jikaro Firering Table 2 Unit Bridge
FES-042
Instruction Manual : Ver 1.00
Contents (Name of the Parts)
Thank you for purchasing a Snow Peak product. This product is a dedicated optional part for camping required to use the center part of the Jikaro Firering Table as a two-unit
IGT. For safety, read the following instruction manual before use. Please keep it safe for future reference. Finally, if you find anything that you do not understand in the description
or any problems with the product, please stop use immediately and contact the retailer or Snow Peak Customer Service.
Before installing this product on a Jikaro Firering Table, read the Jikaro Firering Table's instruction manual carefully to ensure that the Jikaro Firering Table has been correctly set
up. This product supports the assembly pattern where the opening is larger (600 mm both length and width). This cannot be used with the assembly pattern where the opening
is smaller (370 mm both length and width).
This product cannot be used if the Jikaro Firering Table's opening is open on any side. The adjacent tabletop panels must be bolted to each other as shown in the figure
to make a completely closed opening.
Specifications
Material: Body / Stainless Steel, Carry Case /
Polyester
Size: 600×645×30 (h) mm (when assembled) /
645×160×30 (h) mm (when flattened)
Weight: 1.9 kg
Instructions for Use
Maintenance
●Before using a product that has been in storage for a long time, check each part for abnormalities. If there are abnormalities, take the product to the retailer or contact
Snow Peak Customer Service for inspection or repair.
●Cleaning these products with a scrubbing brush or the rough side of a sponge could scratch them.
●After use, remove dirt using a soft cloth wrung out of water and wipe off moisture. Dry completely in a well-ventilated place in the shade. Storing these products while
they are dirty or wet could cause rusting.
●Do not soak-wash these products, or leave them soaked in water for a long time. It can result in rust.
●Do not clean these products using a dish washer or dish dryer.
Repair
●If professional repairs are required, please contact the retailer where you purchased the product or Snow Peak Customer Service.
●When you request repairs, please make sure that the product is dry and clean.
●Please attach a memo or a tag indicating the necessary repair and please write details of how and when the damage occurred.
●Transportation and repair costs are determined as follows.
1. Within warranty: The transportation cost (both ways) and repair cost will be covered by Snow Peak.
2. Outside warranty: The transportation cost (both ways) and repair cost will be covered by the customer.
Warranty
Snow Peak has taken all possible measures to ensure every product is durable and functions correctly. If you find any product defects, please contact the retailer
where you purchased the product or Snow Peak Customer Service. If there are apparent defects in the product's manufacturing, the defective product will be repaired
or exchanged free of charge. In other cases, Snow Peak will repair the product for an appropriate fee. The decision to repair or replace the product will be at our
discretion. Snow Peak will not repair the product for any damage that occurred due to the following:
1. Material deterioration caused by age
2. Damage caused by modifications or rough handling
3. Damage caused by inappropriate use not mentioned
in the instruction manual
4. Damage caused by unexpected accidents
5. Any damage other than defects in the manufacturing process
6. Damage caused by dust or rust
7. Damage and defects caused by dismantling the product
8. Damage and defects caused by dropping, jolting or other shocks
9. Deterioration or failure of parts due to friction
10. Damage caused by the use of the product in combination with another manufacturer's
products
Snow Peak, Inc.
456, Nakanohara, Sanjo-Shi, Niigata 955-0147 Japan
Tel. +81 256-46-5858 / Fax. +81 256-46-5860
www.snowpeak.co.jp
Snow Peak USA, Inc.
404 NW 23rd Avenue, Portland, Oregon 97210, USA
Tel. +1 (503) 461-0781 / Instagram. @snowpeakusa
Email. info@snowpeak.com / www.snowpeak.com MADE IN CHINA
Instruction Manual
(This Manual)×1Storage Case×1Main frame×2 Side frame×2
WARNING / Misuse could result in serious injury or death.
●Before using the product, check each part for abnormalities.If there are abnormalities, take the product to the dealer or Snow Peak Customer Service for inspec-
tion or repair.●Foodstuff and other items placed on the IGT unit must not exceed 20 kg. For structural reasons, loading the table beyond that weight may cause the
table to tip or this product to fall off, which can further lead to fire or burns. ●While using this product, keep the load on the tabletop of the Jikaro Firering Table no
more than 10 kg per panel. Loading the table beyond that weight may cause the table to tip or this product to fall off, which can further lead to fire or burns. To use
this product to expand the Jikaro Firering Table, follow the load limits described in this manual. ●When using gas equipment or a barbecue box, this product and
the Jikaro Firering Table may become hot. Do not touch without protection or place gas canisters, lighters, or other flammable objects on the table. ●Do not allow
use of this product by small children or persons unfamiliar with its handling. Particularly in the presence of children, keep a watch on them to ensure that they do
not play with this product in order to prevent accidents and injuries such as burns.
CAUTION / Misuse could result in injury to the user and/or damage to property.
● This product has protrusions by design. Wear gloves and other protective gear when assembling, taking apart, or maintaining the product to prevent cutting your
fingers. ●If a chemical, condiment, or beverage adheres to the product, wipe it off immediately. Leaving it will result in rust or corrosion. ●Do not place hot pots and
frying pans directly on the product. Putting hot cooking utensils directly on the product may result in discoloration and/or deformation. ●Use this product where it
is not exposed to rain, such as under the tarp or inside the shelter. Leaving it wet can result in rust or discoloration. ●Before changing the layout or location of the
table, be sure to take everything off and remove the product from the Jikaro Firering Table. Moving the Jikaro Firering Table with this product attached may cause
this product and/or assembled parts to fall off the table and result in injury or property damage. ●This product is not for permanent setup. Leaving heavy objects
on the product may distort it. Leaving this product outdoors for a long period of time may result in rusting. ●CK-220 IGT Hanging Rack 2 Frame and other products
with a structure that is suspended from this product cannot be used with this product. The unbalanced load may cause the table to fall over. ●When putting an item
on this product, put it on gently. Applying a strong impact to the unit can result in distortion. ●Due to structural reasons, placing a heavy object on the IGT unit may
create a gap between this product and the Jikaro Firering Table. If the gap is too large, check whether the ground is sloped or whether the table is on a rock, and
ensure use on a level surface.
DANGER / Misuse could easily result in a serious accident or death.
●This product is a dedicated optional part for camping for the Jikaro Firering Table. Do not use this product for any purpose other than attaching it to a Jikaro
Firering Table. ●Before using this product, read the instruction manuals for the Jikaro Firering Table and other assembly parts carefully to ensure good understand-
ing of precautions and how to assemble the products. ●When using this product inside a tent or a shelter, do not use this in combination with a burner or gas
equipment. There is a risk of carbon monoxide poisoning or fire, which may result in death or serious medical conditions. ●Do not use this product in combination
with a campfire stand. It may result in fire and/or property damage. Such use is strictly prohibited. ●To use this product in combination with gas equipment, make
sure to use it away from other heat sources such as open fire or a heater. The gas cartridge may overheat from other heat source and create a risk of explosion.
●For outdoor use, make sure to check beforehand that the ground where the Jikaro Firering Table is set up is level. Using this product on a slope or where the
Jikaro Firering Table is tilted may cause objects placed on the table to slide off or the table to tip, further leading to fire or property damage.
Safety Precautions: Before use, please read thoroughly to ensure safety and avoid accidents.
CAUTION
*Precautions before Use
Installation pattern where the opening is 600 mm Installation pattern where the opening is 370mm
Adjacent tabletop panels are bolted to each other One of the tabletop panels is not connected,
leaving a side of the opening open
Main frame
Main frame
Cross-section viewStopper Slit Detailed view
Main frame fixing tab
Side frame fixing tabs
Attachment holes
Place the two-unit product first and finally
attach the side frames on both sides.
Enlarged view Instruction for mounting a two-unit product
Be sure to use the table on level ground.
Opening
Usable 600 mm Not usable
370 mm
Usable Not usable
Place the two main frames on the center opening of the Jikaro Firering Table.
Insert the stopper of the main frame diagonally so that it gets under the bottom side of the tabletop. Place the main frame gently while ensuring that its fixing tabs
are inserted into the slits in the tabletop. Attach the other main frame to the opposite side in the same way.
Place the side frames. Insert the side frame's fixing tabs into the holes in the main frame and Jikaro Firering Table.
* When using Double Burner Stove or Double Unit BBQ Box, or other two-unit size product, place that product first on the unit and then finally install the side frames.
When taking the assembly apart, remove the sub frames first before removing the product placed on the unit. Always use the side frames when using this product.
Place any product on the unit and check for any warping or rickety part in the entire Jikaro Firering Table setup, including this product.
If the setup is shaky or otherwise unstable, check whether the ground is level and whether any of the Jikaro Firering Table's legs is placed on a rock or other object.
For taking the setup apart, perform the procedure in the reverse order.
/
