Hitachi CS 33EB Handling Instructions Manual

Chain Saw

CS 33EB

Read through carefully and understand these instructions before use.

Handling instructions

2

9

2

1

3

9

11

10

0.5 – 1 mm

6

4

5

8

7

13

12

16

15

14

17

56

57

123

456

789

10 11 12

3

15

18

19

20

21

22

25

23

26

27

24

28

30

29

34

32

33

31

13 14 15

16 17 18

19 20 21

22 23 24

4

0.6 mm

36

35

37

38

39

25 26 27

28 29 30

31 32 33

34 35 36

5

52

49

50

51

53

53 53

54

55

41 40

42

43

44 45

46

47

48

37 38 39

40 41

42 43

6

7

15

16

17

8

○

9

○

10

○

11

○

12

○

13

○

14

○

15

○

16

○

17

MEANINGS OF SYMBOLS

NOTE: Some units do not carry them.

Symbols

WARNING

The following show symbols used for the machine. Be sure that you understand their meaning before use.

It is important that you read, fully understand and

observe the following safety precautions and

warnings. Careless or improper use of the unit may

cause serious or fatal injury.

Oﬀ /Stop

Read, understand and follow all warnings and

instructions in this manual and on the unit.

Emergency stop

Always wear eye, head and ear protectors when using

this unit.

Fuel and oil mixture

Warning, kickback danger. Be careful of possible

sudden and accidental upward and/or backward

motion of the guide bar.

Chain oil ﬁ ll

One-handed usage not permitted. While cutting,

hold saw ﬁ rmly with both hands with thumb ﬁ rmly

locked around front handle.

Carburetor adjustment - Idle speed

Chain brake Carburetor adjustment - Low speed mixture

Choke Carburetor adjustment - High speed mixture

On/Start Priming pump

Contents

WHAT IS WHAT? .............................................................................18

WARNINGS AND SAFETY INSTRUCTIONS .................................19

SPECIFICATIONS ...........................................................................21

ASSEMBLY PROCEDURES ............................................................22

OPERATING PROCEDURES ..........................................................22

MAI NT ENA NCE ............................................................................... 24

18

WHAT IS WHAT?

1. Throttle trigger: Device activated by the operatorʼs ﬁ nger, for

controlling the engine speed.

2. Throttle trigger lockout: Device that prevents the accidental

operation of the throttle trigger until manually released.

3. Ignition switch: Device for allowing the engine to be started or

stopped.

4. Oil tank cap: For closing the oil tank.

5. Recoil starter: Pull handle to start the engine.

6. Front handle: Support handle located at or towards the front of

the engine housing.

7. Fuel tank cap: For closing the fuel tank.

8. Choke lever: Device for enriching the fuel/air mixture in the

carburetor, to aid starting.

9. Priming pump: Device for supplying extra fuel, to aid starting.

10. Guide bar: The part that supports and guides the saw chain.

11. Saw chain: Chain, serving as a cutting tool.

12. Chain brake (Front hand guard): Device for stopping or locking

the chain.

13. Spiked bumper (optional): Device for acting as a pivot when in

contact with a tree or log.

14. Chain catcher: device for restraining the saw chain.

15. Guide bar cover: Device for covering the guide bar and saw

chain when the unit is not being used.

16. Combi box spanner: The tool for removing or installing a spark

plug and tensioning the saw chain.

17. Handling instructions: Included with unit. Read before

operation and keep for future reference to learn proper, safe

techniques.

15

16

17

13

12

11

10

14

8

2

9

6

5

1

3

7

4

19

WARNINGS AND SAFETY INSTRUCTIONS

Operator safety

○ Always wear a safety face shield or goggles.

○ Gloves should be used when sharpening chain.

○ Always wear safety protective equipment such as jacket,

trousers, gloves, helmet, boots with steel toe-caps and non-

slip soles whenever you use a chain saw. For working in trees

the safety boots must be suitable for climbing techniques. Do

not wear loose clothing, jewelry, short pants, sandals or go

barefoot.

Secure hair so it is above shoulder length.

○ Do not operate this tool when you are tired, ill or under the

inﬂ uence of alcohol, drugs or medication.

○ Never let a child or inexperienced person operate the machine.

○ Wear hearing protection. Pay attention to your surroundings.

Be aware of any bystanders who may be signaling a problem.

Remove safety equipment immediately upon shutting oﬀ

engine.

○ Wear head protection.

○ Never start or run the engine inside a closed room or building.

Breathing exhaust fumes can kill.

○ For respiratory protection, wear a protection mask while

emitting the chain oil mist and dust from sawdust.

○ Keep handles free of oil and fuel.

○ Keep hands away from cutting equipment.

○ Do not grab or hold the unit by the cutting equipment.

○ When the unit turned oﬀ , make sure the cutting attachment has

stopped before the unit is set down.

○ When operation is prolonged, take a break from time to time

so that you may avoid possible Hand-Arm Vibration Syndrome

(HAVS) which is caused by vibration.

○ The operator must obey the local regulations of cutting area.

WARNING

○ Antivibration systems do not guarantee that you will not sustain

Hand-Arm Vibration Syndrome or carpal tunnel syndrome.

Therefore, continual end regular users should monitor closely

the condition of their hands and ﬁ ngers. If any of the above

symptoms appear, seek medical advice immediately.

○ Long or continuous exposure to high noise levels may cause

permanent hearing impairment. Always wear approved hearing

protection when operating a unit/machine.

○ If you are using any medical electric/electronic devices such

as a pacemaker, consult your physician as well as the device

manufacturer prior to operating any power equipment.

Unit/machine safety

○ Inspect the entire unit/machine before each use. Replace

damaged parts. Check for fuel leaks and make sure all

fasteners are in place and securely tightened.

○ Replace parts that are cracked, chipped or damaged in any way

before using the unit/machine.

○ Make sure the side case is properly attached.

○ Keep others away when making carburetor adjustments.

○ Use only accessories as recommended for this unit/machine by

the manufacturer.

○ Never let the chain strike any obstacle. If the chain makes

contact, the machine should be stopped and checked carefully.

○ Make sure the automatic oiler is working. Keep the oil tank ﬁ lled

with clean oil. Never let chain run dry on the bar.

○ All chain saw service, other than the items listed in the

operatorʼs/ ownerʼs manual, should be performed by competent

chain-saw service personnel. (For example, if improper tools

are used to remove the ﬂ ywheel or if an improper tool is used

to hold the ﬂ ywheel in order to remove the clutch, structural

damage to the ﬂ ywheel could occur and could subsequently

cause the ﬂ ywheel to burst.)

WARNING

○ Never modify the unit/machine in any way. Do not use your unit/

machine for any job except that for which it is intended.

○ Never use chain saw without any safety equipment or that has

faulty safety equipment. It could result in serious personal

injury.

○ Using guide bar/chain other than recommended by the

manufacturer which are not approved, could result in a high risk

of personal accidents or injury.

Fuel safety

○ Mix and pour fuel outdoors and where there are no sparks or

ﬂ ames.

○ Use a container approved for fuel.

○ Do not smoke or allow smoking near fuel or the unit/machine or

while using the unit/machine.

○ Wipe up all fuel spills before starting engine.

○ Move at least 3 m away from fueling site before starting engine.

○ Stop engine before removing fuel cap.

○ Empty the fuel tank before storing the unit/machine. It is

recommended that the fuel be emptied after each use. If fuel is

left in the tank, store so fuel will not leak.

○ Store unit/machine and fuel in area where fuel vapors cannot

reach sparks or open ﬂ ames from water heaters, electric

motors or switches, furnaces, etc.

WARNING

Fuel is easy to ignite or get explosion or inhale fumes, so that

pay special attention when handling or ﬁ lling fuel.

Cutting safety

○ Do not cut any material other than wood or wooden objects.

○ For respiratory protection, wear an aerosol protection mask

when cutting the wood after insecticide has been applied.

○ Keep others including children, animals, bystanders and

helpers outside the hazard zone. Stop the engine immediately

if you are approached.

○ Hold the unit/machine ﬁ rmly with the right hand on the rear

handle and the left hand on the front handle.

○ Keep ﬁ rm footing and balance. Do not over-reach.

○ Keep all parts of your body away from the muﬄ er and cutting

attachment when the engine is running.

○ Keep Bar/Chain below waist level.

○ Before felling a tree, the operator must be accustomed to the

sawing techniques of the chain saw.

○ Be sure to pre-plan a safe exit from a failing tree.

○ While cutting, hold saw ﬁ rmly with both hands with thumb ﬁ rmly

locked around front handle, and stand with feet well balanced

and your body balanced.

○ Stand to the side of the saw when cutting - never directly

behind it.

○ Always keep the spiked bumper face to a tree, because the

chain may suddenly be drawn into a tree, if so equipped.

○ When completing a cut, be ready to hold up the units as it

breaks into clear, so it will not follow through and cut your legs,

feet or body, or contact an obstruction.

○ Be alert against kickback (when saw kicks up and back at

operator). Never cut with the nose of the bar.

○ When relocating to a new work area, be sure to shut oﬀ the

machine and ensure that all cutting attachments are stopped.

○ Never place the machine on the ground when running.

○ Always ensure that the engine is shut oﬀ and any cutting

attachments have completely stopped before clearing debris or

removing grass from the cutting attachment.

○ Always carry a ﬁ rst-aid kit when operating any power

equipment.

○ Never start or run the engine inside a closed room or building

and/or near the inﬂ ammable liquid. Breathing exhaust fumes

can kill.

Maintenance safety

○ Maintain the unit/machine according to recommended

procedures.

○ Disconnect the spark plug before performing maintenance

except for carburetor adjustments.

○ Keep others away when making carburetor adjustments.

○ Use only genuine HITACHI replacement parts as

recommended by the manufacturer.

CAUTION

Do not disassemble the recoil starter. You may get a possibility

of personal injury with recoil spring.

20

WARNING

Improper maintenance could result in serious engine damage

or in serious personal injury.

Transport and storage

○ Carry the unit/machine by hand with the engine stopped and

the muﬄ er away from your body.

○ Allow the engine to cool, empty the fuel tank, and secure the

unit/machine before storing or transporting in a vehicle.

○ Empty the fuel tank before storing the unit/machine. It is

recommended that the fuel be emptied after each use. If fuel is

left in the tank, store so fuel will not leak.

○ Store unit/machine out of the reach of children.

○ Clean and maintain the unit carefully and store it in a dry place.

○ Make sure ignition switch is oﬀ when transporting or storing.

○ When transporting or storage, cover chain with guide bar cover.

If situations occur which are not covered in this manual, take care

and use common sense. Contact Hitachi Authorized Service

Centers if you need assistance. Pay special attention to statements

preceded by the following words:

WARNING

Indicates a strong possibility of severe personal injury or loss of

life, if instructions are not followed.

CAUTION

Indicates a possibility of personal injury or equipment damage,

if instructions are not followed.

NOTE

Helpful information for correct function and use.

ページが読み込まれています...

Hitachi CS 33EB Handling Instructions Manual

Hitachi CS 33EB Handling Instructions Manual

他の言語で

関連論文

その他のドキュメント