Safety Warning
Thank you for using our Remo4 Bluetooth sound system!
Before using this unit please, read the manual.
This audio system was for indoor use only.
Do not place the apparatus in direct sunlight or heat.
This apparatus should be placed on a stable surface.
Trying to remove panels or repairing the unit by yourself could result in an electric shock.
This item should be connected to an AC 100V-240V Power outlet.
Do not use chemicals on this product.
Do not press the buttons too hard, it may damage the product.
Do not attempt to repair this product as the warranty will be void, please contact with the store or customer service.
Product
NO.PARTS QTY.
①
②
③
④
⑤
⑥
⑦
⑧
⑨
Speaker：3”4Ω10W
C05 control box
The extention cable of speaker：L=1000mm
Speaker inner grill
Screw：KA3*16mm
Screw：PA3.5*15
Speaker grill
Speaker grill fix
Speaker grill fix cover
1PCS
2PCS
4PCS
2PCS
2PCS
8PCS
8PCS
2PCS
2PCS
Basic operation
1. Once power is supplied, the Remo4 bluetooth audio kit begins to search pairing device
automatically. It keeps searching until it pairs with other device successfully. It could
only pair with one bluetooth device. If you want to pair with another device, disconnect
the paired one, then connect with the new one.
2．The Remo4 Bluetooth audio kit could be controlled via the paired bluetooth.
Previous track/ Next track, Increase volume/ Decrease volume, Pause / Play.
3．Description of bluetooth：eMoMo Remo4
4．Bluetooth reproduction rang: 8m.
Specification
Output 8W*2
Signal to noise ratio
Speaker
Blutooth Edition
≥68dB
3"4Ω 10W * 2
5.0
Frequently Asked Qustions
The volume switch is on minimum;
the unit is not set to the correct function;
please contact with the store or customer service.
Problem Possible cause and correction or maintenance
No sound at all
Please close all other pairing machines and retry;
Please wait a few seconds or restart the machine;
Do not pair the devices behind a wall or in corner, please
keep the working space within 8 meters;
Pair the device named eMoMo Remo4.
Bluetooth can
not pair
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
RF exposure statement
This equipment complies with the FCC radiation exposure limits set forth for an uncontrolled environment. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
1
2
