Roland SRX-06 取扱説明書

1

Thank you, and congratulations on your choice of the SRX-06

“SR-JV80 Collection Vol.1 Complete Orchestra” Wave

Expansion Board.

This expansion board contains all of the waveforms used in

the SR-JV80-02 Orchestral, SR-JV80-13 Vocal, and SR-JV80-16

Orchestral II collections, along with specially selected

orchestral sounds from waveforms included in the SR-JV80-

07 SuperSoundSet. This board contains new Patches and

Rhythm Sets which combine the waveforms in a manner that

highlights the benefits of SRX Effects and Matrix Control.

Along with standard orchestral instrument sounds such as

strings, winds, percussion, and piano, the board also contains

a wide variety of choir and vocal phrases. These sounds can

be used in orchestral compositions, music for films, and a

wide variety of other applications.

• Patches: 449

• Rhythm Sets: 5

• Waveforms: 512

* The parameter settings for Patches and Rhythm Sets are optimized for

the Fantom series, XV series, JUNO-G, MX-200, RD series with SRX

slots, MC-909, VR-760, and G-70 models, so there are some minor

differences in the sounds each instrument produces.

The included CD-ROM contains data reproducing the

original sounds of the SR-JV80-02, SR-JV80-13, and SR-JV80-

16. (Compatible models: Fantom (FA-76), XV-5080, XV-5050,

XV-3080, XV-88, XV-2020)

This expansion board utilizes a new format. Check the

system program version for your instrument, and if a

relevant upgrade is available, upgrade your instrument

using the appropriate system update program on the

included CD-ROM. (See p. 15.)

This program applies to the SRX-01–09.

•

201a

Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT

NOTES” (p. 2; p. 4). These sections provide important information concerning the proper operation of the unit.

Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new

unit, Owner’s manual should be read in its entirety. The manual should be saved and kept on hand as a

convenient reference.

SRX-06_je 1 ページ２００６年５月１５日　月曜日　午前１１時２分

ページが読み込まれています...

3

SRX-06_je 3 ページ２００６年５月１５日　月曜日　午前１１時２分

4

IMPORTANT NOTES

When you purchase the SRX-06 expansion board from an

authorized Roland dealer, the included sounds and samples

are licensed, not sold, to you by Roland Corporation, for

commercial use in music production, public performance,

broadcast, etc.

You may use any of the included phrases and/or samples in

a commercial or non-commercial recording without paying

any additional license fees. However, you must strictly

adhere to the following crediting guidelines on any music

recording that utilize material from SRX-06.

Reproduction or duplication of this collection or any of the

sound recording contained in the SRX-06, either as they exist

on this expansion board or by any means of reformatting,

mixing, filtering, re-synthesizing, processing or otherwise

editing for use in another product or for re-sale, is strictly

prohibited without the express written consent of Roland. All

unauthorized giving, trading, lending, renting, re-issue, re-

distribution or re-sale of the sounds included in the SRX-06

are expressly prohibited.

In Plain English: Be creative in your application of the SRX-06

sounds, and keep this library for your use only. DO NOT COPY IT.

Roland constantly monitors other Soundware releases to

check for copyright infringements, and will prosecute all

piracy and copyright violations to the fullest extent of the law.

THIS LIBRARY IS GUARANTEED TO BE 100%

COPYRIGHT CLEAN.

291a

“

”

Handling CD-ROMs

801

* Avoid touching or scratching the shiny underside (encoded

surface) of the disc. Damaged or dirty CD-ROM discs may not

be read properly. Keep your discs clean using a commercially

available CD cleaner.

Handling the Board

901

To avoid the risk of damage to internal components that can

be caused by static electricity, please carefully observe the

following whenever you handle the board.

1

* Before you touch the board, always first grasp a metal object

(such as a water pipe), so you are sure that any static

electricity you might have been carrying has been discharged.

2

* When handling the board, grasp it only by its edges. Avoid

touching any of the electronic components or connectors.

5

* Save the bag in which the board was originally shipped, and put

the board back into it whenever you need to store or transport it.

901 (F)

Veuillez suivre attentivement les instructions suivantes quand

vous manipulez la carte afin d’éviter tout risque

d’endommagement des pièces internes par l’électricité statique.

1

* Toujours toucher un objet métallique relié à la terre (comme

un tuyau par exemple) avant de manipuler la carte pour vous

décharger de l’électricité statique que vous auriez pu

accumuler.

2

* Lorsque vous manipulez la carte, la tenir par les côtés. Évitez

de toucher aux composants ou aux connecteurs.

5

* Conservez le sachet d’origine dans lequel était la carte lors de l’envoi

et remettez la carte dedans si vous devez la ranger ou la transporter.

SRX-06_je 4 ページ２００６年５月１５日　月曜日　午前１１時２分

5

21 3

Wave Expansion Board (SRX series)

Carte d'extension Wave (serie SRX)

Connector

Connecteur

Board holder

Support à carte

Position them as shown before you install the board.

Avant l’installation, orienter les supports à carte tel qu’indiqué sur le schéma.

LOCK

Installation tool

Outil d'installation

Screwdriver

Tournevis

INSTALLING THE WAVE EXPANSION BOARD

* Turn off your instrument.

1.

Remove the cover located on the top (or rear) of your

instrument.

928

* When turning the unit upside-down, get a bunch of newspapers or

magazines, and place them under the four corners or at both ends to

prevent damage to the buttons and controls. Also, you should try to

orient the unit so no buttons or controls get damaged.

929

* When turning the unit upside-down, handle with care to avoid

dropping it, or allowing it to fall or tip over.

2.

Insert the Wave Expansion Board connector into a connector

for an SRX Series slot, while simultaneously inserting the

board holders into the holes in the Wave Expansion Board.

911

* Do not touch any of the printed circuit pathways or connection

terminals.

912

* Never use excessive force when installing a circuit board. If it doesn’t

fit properly on the first attempt, remove the board and try again.

3.

Use the supplied Installation Tool to turn the holders in the

LOCK direction, so the board will be fastened in place.

(To remove the Wave Expansion Board, turn the board holders

in the UNLOCK direction, and lift up the board.)

913

* When circuit board installation is complete, double-check your work.

4.

Using the screws removed in Step 1, refasten the cover in its

original position.

5.

Check if the Wave Expansion Board is correctly installed.

* If the “EXP” display cannot be selected (doesn’t appear) in the

Waveform Selection Screen (refer to the owner’s manual of the

instrument you use), remove the Wave Expansion Board and install it

properly.

* Éteindre l'instrument.

1.

Retirer le couvercle situé sur le dessus (ou á l'arrière) de

l'instrument.

2.

Inserer le connecteur de la carte dans un des creneaux pour

la serie SRX tout en enfoncant les supports a carte dans les

trous de celle-ci.

911(F)

* Ne pas toucher aux circuits imprimés ou aux connecteurs.

912(F)

* Ne jamais forcer lors de l’installation de la carte de circuits imprimés.

Si la carte s’ajuste mal au premier essai, enlevez la carte et

recommencez l’installation.

3.

Utiliser l'outil d'installation fourni pour tourner les clips de

retenue vers la position de blocage (LOCK) de façon á ce que

la carte soit retenue en place.

(Pour retirer la carte d'expansion Wave, tourner les clips de

retenue de la carte vers la position déblocage (UNLOCK) et

retirer la carte en la soulevant.)

913(F)

* Quand l’installation de la carte de circuits imprimés est terminée,

revérifiez si tout est bien installé.

4.

Remettre la plaque a sa place et la fixer a l'aide des vis

enlevees a l'etape 1.

5.

S'assurer que la carte d'expansion Wave est installée

correctement.

* S'il est impossible de sélectionner l'affichage “EXP” (il n'apparaît

pas) á l'écran de sélection Waveform (se reporter au guide du

propriétaire de l'instrument utilisé), retirer la carte d'expansion Wave

et la réinstaller correctement.

1.

2.

3.

4.

5.

SRX-06_je 5 ページ２００６年５月１５日　月曜日　午前１１時２分

ページが読み込まれています...

14

* Used only in the menu waveforms.

Menu Waveform

393 Vocal Menu L

C4 359 Tenor Solo

D4 395 BoysAleluiaL

E4 397 Boys Amen1 L

F4 399 Boys Amen2 L

G4 401 Amen L

A4 403 Aleluia L

394 Vocal Menu R

C4 359 Tenor Solo

D4 396 BoysAleluiaR

E4 398 Boys Amen1 R

F4 400 Boys Amen2 R

G4 402 Amen R

A4 404 Aleluia R

450 Bodhran Menu

C4 451 Bodhran 1

D4 452 Bodhran 2

E4 453 Bodhran 3

F4 454 Bodhran 4

G4 455 Bodhran 5

A4 456 Bodhran 6

B4 457 Bodhran 7

501 REV VoMenu L

C4 503 REV ByAleluL

D4 505 REV ByAmen1L

E4 507 REV ByAmen2L

F4 509 REV Amen L

G4 511 REV AleluiaL

A4 REV Jazz Doot L *

B4 REV Jazz Dat L *

C5 REV Jazz Bap L *

D5 REV Dow fall L *

E5 REV Bass Thum *

502 REV VoMenu R

C4 504 REV ByAleluR

D4 506 REV ByAmen1R

E4 508 REV ByAmen2R

F4 510 REV Amen R

G4 512 REV AleluiaR

A4 REV Jazz Doot R *

B4 REV Jazz Dat R *

C5 REV Jazz Bap R *

D5 REV Dow fall R *

E5 REV Bass Thum *

SRX-06_je 14 ページ２００６年５月１５日　月曜日　午前１１時２分

15

About the New Format

Expansion boards SRX-01–04 could only hold a maximum of

128 Patches. In order to make it possible to provide an even

greater variety of sounds, a new format (implemented

originally on the SRX-05) is now being employed. This new

format is capable of handling more than 128 Patches.

If you are using one of the five models listed below, and are

still using an older version of the system, you may need to

upgrade its system to enable it to support the new SRX

format. Check the system program version of your

instrument; if your current version is the same as, or older

than the corresponding one listed below, use the system

update program on the included CD-ROM to upgrade to the

latest version before using the SRX-06.

• Fantom (FA-76): Update required for versions up to Ver. 1.12

• XV-5080: Update required for versions up to Ver. 1.24

• XV-3080: Update required for versions up to Ver. 1.08

• XV-88: Update required for versions up to Ver. 1.07

• RD-700: Update required for versions up to Ver. 1.04

For instructions on checking the system program version for

each instrument, and upgrading the software, refer to the

html files for the relevant instrument included on the CD-

ROM.

About the Included CD-ROM

The included CD-ROM features:

• System update programs compatible with new-format

SRX expansion boards (for Fantom (FA-76), XV-5080,

XV-3080, XV-88, and RD-700)

• Data Reproducing the SR-JV’s Original Patches and

Rhythm Sets (Compatible models: Fantom (FA-76),

XV-5080, XV-5050, XV-3080, XV-88, XV-2020)

• SRX-01–09 demo songs

• BPM Conversion Table

(The BPM conversion table cannot be used with the SRX-

06, since it does not have any phrase loop waveforms.)

For more detailed information on each file, refer to

index_e.html on the CD-ROM.

* Take proper care of the included CD-ROM; it will not be

reissued.

* The system programs on the included CD-ROM are the latest

versions, as of September, 2002. For information regarding

newer versions than those on this disk, you should contact the

nearest Roland Service Center.

•

SRX-06_je 15 ページ２００６年５月１５日　月曜日　午前１１時２分

16

SRX-06 “Complete Orchestra”

*03122756- 08*

03122756 06-06-8N

202

CORPORATION.

©

This warranty is valid only in Japan.

SRX-06_je 16 ページ２００６年５月１５日　月曜日　午前１１時２分

Roland SRX-06 取扱説明書

Roland SRX-06 取扱説明書

他の言語で

関連論文

その他のドキュメント