140 mm (5.51")
Wall mounting instructions
Drill holes on wall at hole
positions marked.*
EN
Note for mounting
To secure the mounting on wall, concrete wall is required.
Use screws to mount the device on the wall
1 Use this sheet as a template. Mark the position where you
want to hang the device on the wall (as shown above) and
then drill two 6mm diameter holes.
2 Secure the 2 dowels and 2 screws (both supplied) in the
holes respectively. Leave a gap of 5 mm between the head
of the screw and the wall.
3 Hang the device on the fastening screws.
ZH-TW
安裝注意事項
要確保穩固，請在水泥牆上安裝。
使用螺絲釘將裝置安裝在牆面上
1 將這張單子作為標示樣本。
在您想懸掛裝置的牆面標記位
置
(
如上所示
)
，然後鑽二個直徑
6
公釐的洞。
2 在鑽孔處安裝隨附的
2
根暗榫與
2
根螺絲釘。
螺絲釘頭
與牆面間保持
5
公釐的間隙。
3 將裝置掛在固定的螺絲上。
壁掛指示
在牆上標示處進行鑽孔。
*
BTM2460_96_Wall Mounting_v1.0
-
1
