ENGLISH
Note for mounting
To secure the mounting on wall, concrete wall is required.
Use screws to mount the main unit on the wall
1. Use this sheet as a template. Mark the position where you want to hang the unit on the wall (as shown above) and then drill
two 6mm diameter holes.
2. Secure the 2 dowels and 2 screws (both supplied) in the holes respectively. Leave the screws 5mm proud of the wall.
3. Hang the unit on the fastening screws.
简体中文
安装注意事项
要确保在墙上稳固安装，必须是水泥墙。
使用螺钉将主装置安装在墙上
1.
使用此纸张作为模板。标记您要在墙上悬挂装置的位置（如上所示），然后钻两个直径为 6 毫米的孔。
2.
将 2 个销子和 2 枚螺钉（均随附）分别固定在孔中。让螺钉头和墙壁之间保持 5 毫米的间隙。
3.
将装置挂在紧固螺钉上。
*
壁装说明
在墙上标记孔位置处钻孔。
146 mm (5.75")
Wall mounting instructions
Drill holes on wall at hole
positions marked.*
DCM2060_93_Wall Mounting_V1.0
-
1
