R
THE FINEST RADIO CONTROL MODELS
INSTRUCTION SHEET
No.82041
Before beginning assembly, please read these instructions thoroughly!
© Copyright 2019 KYOSHO CORPORATION
*SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Receiver Unit RA-41 (KT-531P/KT-432PT)
for MINI-Z EVO Series
Thank you for purchasing this set. Before installation, please carefully
read and follow the instructions on this sheet in conjunction with the
instruction manual in your Chassis set.
CAUTION Be sure to remove the battery for operation before assembling or disassembling the chassis.
1
2
1903-1 PRINTED IN JAPAN
www.kyosho.com
82041-T01
By using this product, can use Mini-Z EVO series chassis with
KT-531P or KT-432PT transmitter.
243-0021
046-229-4115
()13001800
IInstall the receiver unit in the chassis referring to the instruction manual of the MINI-Z EVO Chassis Set. When using
the KT-432PT, download and install the latest firmware of the KT-432PT from the MINI-Z Support Page at the URL below.
You can adjust the gyro assist amount from the transmitter when the optional gyro unit (MZW405) is installed in the
MINI-Z EVO chassis. Please refer to the following instructions to setup the gyro effect.
Only steering gyro amount can be adjusted. Throttle gyro amount is always set to zero.
Steering and throttle gyro functions can be assigned to either
TR3, TR4 or TR5 from the “Keys function” menu, and the gyro
amount can be adjusted independently by those control switch
/dials.
Gyro amount is zero at the center.
Gyro amount increases by turning either left or right regardless of the direction.
http://www.kyosho.com/mini-z-support/
/
<KT-531P>
<KT-432PT>
/