Thank you for purchasing the Mini-Z Evo receiver RA-42. This receiver is
designed for use with the Kyosho Mini-Z Evo and Futaba T-FHSS Mini-Z
system transmitter.
*Futaba T-FHSS Mini-Z system does not work with other communication systems.
*This receiver is T-FHSS system, but the telemetry function isn't equipped.
Bring the transmitter
and the receiver close to
each other, within 20
inches (half meter).
Turn on the transmitter. Place the transmitter
into the receiver linking mode.
*Refer to the transmitters operation manual for complete
details on how to place the transmitter into the linking
mode.
Turn on the receiver.
Press Link SW on the receiver for 2 seconds or more.
Release the link mode of the transmitter. Completed with LED solid
on the receiver.
* If there are many T-FHSS Mini-Z systems turned on in close proximity, your receiver might
have difficulty establishing a link to your transmitter. This is a rare occurrence. However,
should another T-FHSS Mini-Z transmitter/receiver be linking at the same time, your
receiver could link to the wrong transmitter. This is very dangerous if you do not notice this
situation. In order to avoid the problem,we strongly recommend you double check whether
your receiver is really under control by your transmitter.
This device, trade name Kyosho Corporation, model number RA-42, complies with part15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
The responsible party of this device compliance is:
Kyosho America
20322 Valencia Circle Lake Forest, CA. 92630-8158 US
(1)949 454 8854
Kyosho Japan
Atsugi AXT Main Tower 7F 3050 Okata Atsugi, Kanagawa 243-0021 JAPAN
(81)46 229 1511
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Declaration of Conformity
Hereby, Kyosho Corporation declares that the radio equipment type RA-42 is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
http://kyosho.com/eng/support/doc/index.html
CAN ICES-3(B)/NMB-3(B)
Futaba/Kyosho Mini-Z Evo receiver Frequency band: 2.4GHz band
System: T-FHSS Mini-Z Power requirement: 3.3V(Supplied from Mini-Z BASE PCB
Size: 0.55x0.79in (14x20mm) Weight: 0.03oz (0.9g)
KYOSHO CORPORATION
Atsugi AXT Main Tower 7F, 3050 Okata Atsugi, Kanagawa, JAPAN 243-0021
Release the Link SW.
LED 2 seconds solid → Blink
-
1
-
2
他の言語で
関連論文
-
Kyosho No.31255�@V-ONE RR EVOLUTION SERIES ユーザーマニュアル
-
-
-
-
-
-
-
-
