ANT 1 ANT 2
SERVICE
POWER
12V
VIDEO
REMOTE
L
OUTPUT
RAUDIO
OUTPUT
INPUT
REMOTE
ANT 1
VIDEO
REMOTE
Digital TV Tuner
Installation/connections
Notice to dealers and installers
Please return this manual to the customer after the installation is
completed.
2006 Sony Corporation Printed in Thailand
XT-DTV20LN
2-666-624-11(1)
Warning
Do not disassemble or remodel the unit.
This can cause electric shock, personal injury or fire. Do not connect any other system’s power
supply cord to the unit’s power supply cord directly. If you are in any doubt about the safe
installation of this unit, please consult your nearest Sony dealer.
Do not damage any pipes, tubes, fuel tank or electric wiring system when installing
this unit.
This can cause fire. Before drilling any holes in car panels for the installation of this unit, make
sure the installation will not damage any hidden car parts.
Do not use any nuts or bolts connected to the steering linkage, fuel supply or braking
systems.
This can cause fire or loss of control of the car.
Do not mount the Digital TV Tuner unit where it will interfere with the airbag system.
This may cause the airbag to malfunction and injury to the passenger in case of a crash.
Caution
• This unit is designed for negative earth 12 V DC operation only.
•Do not get the wires under a screw, or caught in moving parts (e.g. seat railing).
• Before making connections, turn the car ignition off to avoid short circuits.
• Connect the red power input leads only after all other leads have been connected.
• Be sure to connect the red power input lead to the positive 12 V power terminal which is
energized when the ignition key is in the accessory position.
After installing and connecting the unit, tape the cords to tie them up in a bundle so it will not
interfere with normal driving operations. Be sure that the steering, shift lever and brake pedal do
not get tangled in the cords.
It is very dangerous for the cords to become tangled with the gearshift lever during driving.
Notes
• Secure the connecting cords away from the seat adjustment rails and the door frame.
• Make sure all other electric devices such as brake lights and headlights are working properly after installation is
completed. Also check that the indicators turn on and the horn works properly.
Fuse replacement
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after
replacement, there may be an internal malfunction.
Warning
Use a fuse with the specified amperage rating. Use of a higher amperage fuse may cause serious
damage to the unit.
Parts list (1)
The numbers in the list are keyed to those in the instructions.
Connection example (2)
Connecting with MEX-R1 and XVM-F65 ( 2-1)
Connecting with MV-700HR ( 2-2)
Connection diagram (3)
Notes
• Be sure to connect the power input cord after all other cords have been connected.
• Be sure to insert each connector securely, as vibration through driving may cause a poor connection.
• When removing the cable, hold the connector to avoid damages.
Installing the Digital TV Tuner unit (4)
Notes
•Ensure that the mounting surface is clean.
• Do not install the Digital TV Tuner unit
- in locations subject to high temperatures.
- in locations subject to direct sunlight, warm air from heater outlets, or other locations that can get hot.
1 Attach the clamps 3 with supplied screws 4 (4-1).
2 Cut the carpet in the car and cover the edges of the clamps (4-2), or fix the unit with screws (not supplied) (4-
3).
Attaching the remote control sensor to the car
Attach the remote control sensor on the dashboard, etc. using the two-sided tape 5 .
Keep the units and connection cables apart.
The monitor, Digital TV tuner and RCA interconnects should not be in close proximity. Otherwise
noise interference may affect the TV picture.
1
Power cable 1
1
12 3
45 6
Front monitor system
*1
INPUT
OUTPUT
2-1
INPUT
OUTPUT
2-2
Multi Disc Player
*2
Rear monitor system
*1
*1
XVM-F65 (not supplied)
*2
MEX-R1 (not supplied)
Connection box
Connection box
Digital TV Tuner unit XT-DTV20LN
Clamp 3
3
Portable DVD Player
*
Portable DVD Player
*
*
MV-700HR (not supplied)
Connection box
Connection box
Digital TV Tuner unit XT-DTV20LN
S
IG
N
A
L
@
/
1
XT-DTV20LN
4
4
S
I
G
N
A
L
@
/
1
S
I
G
N
A
L
@
/
1
Remote control sensor 2
2
Audio/video cable
(not supplied)
Fuse (5A)
Fuse (1A)
Yellow
Red
Black
To car battery
(12 V)
To ignition
switch
To a metal
surface of the
car chassis
Connection box
Portable DVD Player MV-700HR Mobile Monitor XVM-F65
Antenna 6
6
Antenna 6
6
3
4-1
4-2 4-3
× 4
× 2
× 2
•
•
•
•
•
•
•
1
2
2
2
3
•
•
•
4
•
•
1 3 4 4
2 4 4
5