Model: BR03-11
Turn ON/OFF
Set to 50% brightness.
Dimming
Indicator
Function
Pair and unpair
Specification
Working voltage
Wireless protocol
Frequency band
Wireless power
Working temperature
DC 3V, CR2032 battery
Umi protocol based on SIG BLE Mesh
2.4GHz ISM band
< 7dBm
-20-55 C(-4-131 F)
Battery:
CR2032
Remove
before use
The remote controller needs to be paired to receiver to work. User can pair
up to 5 remote controllers to one receiver and each remote controller can be
paired to any receiver.
To pair or unpair remote to the receiver, please operate with following steps:
1). Cut off the power of receiver and power on again after more than 5
seconds.
2). Press remote and key simultaneously and briefly within 10 seconds
after receiver powered on.
3). Release all keys, then press key within 10 seconds to pair the remote
to the receiver.
4). To unpair the remote from receiver, do the step 1-2 first, then release all
keys and press key within 10 seconds.
10%
50% Set to 10% brightness.
10%
50%
100%
Set to 100% brightness.
LED Remote Controller
Umi Smart Wireless
型号:B R03-11
设置为50%亮度
功能
配对与取消配对
10%
50%
遥控器需要与灯具或控制器配对才能⼯作。⼀个灯具或控制器最多可
以配对5个遥控器，遥控器则可以与任意灯具或控制器配对。
请按以下步骤操作来完成遥控器配对或取消配对：
1).将⽬标灯具或控制器断电，在超过5秒后再通电。
2).在灯具或控制器通电后的10秒内，同时短按遥控器上的与
键。
3).松开所有按键，然后在10秒内再按键完成配对。
4）.要取消遥控器配对，请先执⾏步骤1-2，然后松开所有键并在10秒
内再按下键来取消配对。
10%
50%
100%
开/关
设置为100%亮度
调节亮度
指⽰灯
设置为10%亮度
电池:
CR2032
使⽤前取
下绝缘⽚
规格
⼯作电压
⽆线协议
频段
⽆线功耗
⼯作温度
DC3V,CR2032纽扣电池
Umi协议，基于SIGBLEMesh
2.4GHzISMband
<7dBm
-20-55°C(-4-131°F)
Umi智能⽆线
LED遥控器
/
