14
2. Channel adjustment
3. Pair all receivers with one key
4. Turn off all receivers with one key
5. MP3 related operation
After unlocking, adjust to the desired channel by pressing the ▲ or ▼ key.
Turn on the power switch of the receiver, and after the transmitter is unlocked,
press the ▲ or ▼ key to adjust to the desired channel, the indicator light of the
transmitter will illuminate green. When the indicator light goes off and the
symbol disappear from the display screen, the pairing is successful.
To power off all receivers, press and hold the ▲ key and turn on the transmitter,
the transmitter screen will prompt "Off All Ear", and its indicator will illuminate
green.
When powered on normally, press the play button to play, and then press
this button again to pause. If you want to select the previous or next track, just
press or , and the ID of the currently playing track will appear on the
display. If you need to enter a specific track to play, you need to enter the
required track ID when paused. (Note: Enter three digits)
During MP3 playback, press the SET button to set single-cycle or all-cycle
mode. When the display shows , it means that the current track is being
played in a single loop; when the display shows , it means that all the
tracks in this folder are played in a loop. If there is no display symbol, it means
that it will stop playing after the current track finishes.
a) MP3 playback settings
b) MP3 playback mode setting
1
A
WTG-700 Tour Guide System