Left Side Coupling Bolt for Nut Type Hub
• The replacement extended left side coupling bolt for mounting the
width is narrower than 120mm.
• Available for GYRO and new M-series frame only.
• Not compatible with any quick release type skewers.
7 4 0 9 6 6 4 0 5 4 1 8
4 9 4 4 9 2 4 4 0 5 4 1 0
UPC
EAN
1.
Loosen the Lock Ring (UF-9 or UF-18) then
remove the original Left Side Coupling Bolt
(UF-8).
2.
Replace the Lock Ring from the original
coupling bolt to the new one.
3.
Screw the new bolt into the thread.
4.
Adjust the coupling bolt position then tighten
position.
1.
2.
3.
4.
NOTE /
If you mount a bike with 130mm or wider rear hub width frame even while installing this longer coupling
bolt, you may have to remove the black plastic outer cap from the left side main pillar.
CONTACT /
MINOURA JAPAN
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone: +81-584-27-3131
Fax: +81-584-27-7505
Mail: [email protected]
Web: www.minoura.jp
Phone: (0584) 27-3131
Fax: (0584) 27-7505
Mail: [email protected]
Web: www.minoura.jp
Made in China /
/