Philco PC900SLE ユーザーマニュアル

USER MANUAL

用戶手冊

PC900SLE

2

3

Dear Customer

Thank you for buying our range hood. Please read the user manual

carefully and store in a handy place for later reference.

This hood is designed for install on walls.

Read the following carefully to avoid damage or injury.

SAFETY AND WARNINGS

●Where applicable, this appliance is supplied with fixings. Please

ensure you use the correct fixings suitable for the substrate where

the appliance will be installed and that they are able to support the

weight of the appliance.

● Before connecting the hood, check that the supplied voltage and

frequency match with that indicated on the appliance rating plate.

If in doubt, ask for advice instore or from a qualified installer..

●If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similar qualified persons in

order to avoid a safety hazard.

●Use only the same size of fittings and mounting screws as

recommended in this instruction manual. Failure to follow these

instructions may result in electrical hazards.

●Means for full disconnection must be incorporated in the fixed

wiring in accordance with the local wiring installation rules for

your country. An all-pole disconnection switch having a contact

separation of at least 3mm in all poles should be connected

during installation.

● When the cookerhood is located above an appliance, the

minimum distance between the supporting surface for the cooking

vessels on the hob and the lowest part of the hood shall be at

least 650mm.

● Consult local regulations regarding extraction outlets and ensure

these are complied with. Do not connect the hood to a ventilation

EN

4

or hot air duct containing combustion fumes from burning gas or

other fuels. Confirm that room ventilation is appropriate with the

local authorities.

● The air must not be discharged into a flue that is used for

exhausting fumes from appliances burning gas or other fuels

●The hood may stop working during an electrostatic discharge

(e.g. lightning). This involves no risk of damage. Switch off the

electricity supply to the hood and reconnect after one minute.

● This appliance can be used by children aged from 8 years and

above and persons with reduced physical, sensory or mental

capabilities or lack of experience and knowledge if they have

been given supervision or instruction concerning use of the

appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance. Cleaning and user

maintenance shall not be made by children without supervision.

● This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities, or

lack of experience and knowledge, unless they have been given

supervision or instruction concerning use of the appliance by a

person responsible for their safety.

●Children should be supervised to ensure that they do not play

with the appliance.

●Do not install the appliance outdoors in a damp place or in an

area which may be prone to water leaks such as under or near a

sink unit. In the event of a water leak affecting the appliance, do

not use and contact customer services to arrange for inspection.

Do not use flammable sprays in close vicinity to the appliance.●

● Please dispose of the packing material carefully. There is a

fire risk if cleaning is not carried out in accordance with the

instructions. Refer to the Care and Maintenance sections carefully

for details on how to clean and replace the aluminium and carbon

filters (if fitted).

● Refer to the Care and Maintenance section for details on the type

of lamps that can be used and how to replace them.

● Do not use a steam cleaner for care and maintenance.

●The appliance is not intended to be operated by means of an

5

external timer or separate remote control system.

● There shall be adequate ventilation of the room when the hood is

used at the same time as appliances burning gas or other fuels.

Ensure that the negative pressure of the installation site does not

exceed 4 Pa (0.04 mbar) to ensure combustion fumes are not

drawn back into the room.

● Do not use the hood if it shows signs of damage or imperfection.

Contact customer services for assistance.

Switch off the appliance at the mains supply before carrying out●

any maintenance work or cleaning.

●CAUTION: Accessible parts may become hot when used with

cooking appliances.

●Do not flambé under the hood. To avoid the risk of fire, clean

or replace the grease filter regularly and closely monitor pans

containing hot oil.

●The manufacturer declines all liability for personal or material

damage as a result of misuse or incorrect installation of this

appliance.

● The appliance is for domestic use only as an extractor hood.

INSTALLATION INSTRUCTIONS

All installation must be carried out by a competent person or

qualified technician. Before connecting the mains supply ensure that

the mains voltage corresponds to the voltage on the rating plate.

The appliance must be connected directly to the mains using an

omnipolar circuit breaker with a minimum opening of 3mm between

the contacts.

The installer must ensure that the correct electrical connection has

been made and that it complies with the wiring diagram.

Regularly check the power plug and power cord for damage. If the

supply cord is damaged, it must be replaced by a special cord or

assembly available from the manufacturer or its service agent.

WARNING: This is a Class II appliance and MUST NOT be

earthed.

6

Contents of packaging

Rangehood

(1)

Ø150mm

Ducting adapter

(1)

Chimney (Upper+lower)

(1)

Reducer Ø150mm to

Ø125mm adapter

(1)

Expansion plug

(8)

Screws

(8) (ST 4x32mm)

Screws

(4) (ST 4x12mm)

Upper chimney bracket

(1)

Chimney bracket

(1)

7

INSTALLATION

Positioning

top of cooking

surface

Fixing dimensions

WARNING!

these instructions may result in electrical hazards.

900

500

56

538

320

290

Min 745/Max 1030

8

● Mark the location for flue cover wall mounting brackets, rangehood

mounting points and anti-tilt fixing points above the rangehood

using the base as the reference point (Fig. 1).

Drilling holes

250 mm

23.5 mm

250 mm

Upper chimney extension

bracket attachment points

Chimney bracket

attachment points

Upper hood

attachment points

Lower hood

attachment points

580 mm

36 mm

286 mm

559 mm

Fig.1

● Attach the upper hood mounting screws in the locations shown

in Fig.2. Use the ST 4x32 mm screws and expansion plugs if

attaching to masonry.

Attach chimney brackets and hood mounting screws

9

● Remove the aluminium filters from the rangehood body and hang

it on the mounting screws then secure at the anti-tilt locations as

indicated in Fig. 3.

Attached hood on wall

2mm

Fig.2

Fig.3

10

● Connect Ø150mm ducting adapter to the blower outlet and use

screws ST 4x12mm to fix it to the range hood (Fig. 4).

Connect ducting adapter

Fig.4

Ø150mm

Ducting adapter

Ø150 to Ø125mm

adapter

●If necessory, connect the Ø150 to Ø125mm adapter to the

Ø150mm ducting adapter (Fig. 4).

Important! For best performance, Ø150mm ducting is

recommended (Ø125mm ducting can be used, but will reduce

the airflow of the cooker hood).

● If need exhaust air to the outside.

Connect Ø150 mm or Ø125 mm

flexible duct to the adapter and

fix it (Fig. 5).

Fixing flexible duct

Fig.5

11

Attach the chimney

● Fix the chimney to the top bracket

using two screws ST 4x12mm.

Connect top of the ducting tube to

vent kit as per manufacturers

Connect ducting adapter

Fig.6

Fig.7

● Install back the aluminium filters to

rangehood, and remove the

protection film from rangehood and

chimney.

instructions (Fig. 7).

12

OPERATING INSTRUCTIONS

Control panel features

12 3 4 5

1 – Filter clean warning display/button.

Remind to replace the filter after the extractor fan working 50 hours.

Press it to deactivate once the filter has been cleaned or replaced.

2 – Enable and disable extractor fan timer.

The extractor fan works at current speed for 5 minutes and downs to

the lower speed for 5 minutes until it stops.

3 – Lighting on and off. Keep pressed down to adjust the lighting intensity.

4 – On/Off button

5 – Fan speed – 1, 2 and 3.

CLEANING AND MAINTENANCE

Warning: always switch off the electricity supply before

carrying out maintenance work on the hood. In the event of a

fault, contact an official distributor or Customer Service.

Exterior Cleaning : Use non-corrosive, liquid detergent and avoid the

use of abrasive cleaning products.

Replacing the lamp

Ensure that the rangehood is unplugged, then slide out the

retractable hood and remove the filters. Turn the lamp anti-clockwise

to remove then replace the lamp by turning it clockwise.

Turn the hood on for a few minutes before you start cooking.

The hood should be left on for a minimum of 5 minutes after cooking or

until all odours have dispersed.

●

Warning: the lighting should not be used as permanent

light source but only for cooking.

Note that lamps become hot when in use. Allow the lamps to cool

down for a few minutes before changing them.

13

from the manufacturer.

≤ 65ºC

1 MONTH

OFF

FUSE

10’

14

3 MONTHS

Troubleshooting

Problem Possible cause Solution

Excessive vibration. The appliance is not installed

properly on the brackets.

Take down the appliance and check

The fan blade is damaged.

Switch off the appliance. Repair to

personnel only.

The light is on, but the

fan does not work.

The fan blade is jammed.

The motor is damaged.

Both the light and

motor do not work.

Light bulb blown. Replace with a bulb of the

correct rating.

Power connection loose. Check power supply.

Suction

performance reduced.

Speed may be too low. Select a higher speed.

are dirty. Care and maintenance section).

Top vent might be

obstructed.

Clear any obstruction.

Optional vent kit might be twisted. Ensure that the vent kit

manufacturer’s instructions.

The installation may not comply with

the manufacturers instructions.

The vent hose should be correct

diameter throughout with no

reductions or restriction.(See

installation section).

Works normally but

cooking smells linger. recirculation mode or is full

of grease. maintenance section).

Replacing Activated charcoal filters

Replace Activated charcoal every 3 months

15

Recycling & disposal

The symbol on the product or on its packaging indicates

that this product may not be treated as household waste.

Instead it shall be handed over to the applicable collection

point for the recycling of electrical and electronic

equipment.

By ensuring this product is disposed of correctly,

you will help prevent potential negative consequences for the

environment and human health, which could otherwise be caused

by inappropriate waste handling of this product.

For more detailed information about recycling of this product, please

contact your local city office, your household waste disposal service

or the shop where you purchased the product.

16

17

●

3

650

18

19

20

(8) (ST 4x32mm)

(4) (ST 4x12mm)

ページを読み込んでいます...

Philco PC900SLE ユーザーマニュアル

Philco PC900SLE ユーザーマニュアル

他の言語で

関連論文

その他の書類