Philco PC700SNL ユーザーマニュアル

USER MANUAL

用戶手冊

PC700SNL

PC900SNL

PC1200SNL

2

3

Dear Customer

Thank you for buying our range hood. Please read the user manual

carefully and store in a handy place for later reference.

This hood is designed for install on walls.

Read the following carefully to avoid damage or injury.

SAFETY AND WARNINGS

●Where applicable, this appliance is supplied with fixings. Please

ensure you use the correct fixings suitable for the substrate where

the appliance will be installed and that they are able to support

the weight of the appliance.

●Before connecting the hood, check that the supplied voltage and

frequency match with that indicated on the appliance rating plate.

If in doubt, ask for advice instore or from a qualified installer..

●If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified persons in

order to avoid a safety hazard.

●Use only the same size of fittings and mounting screws as

recommended in this instruction manual. Failure to follow these

instructions may result in electrical hazards.

●Means for full disconnection must be incorporated in the fixed

wiring in accordance with the local wiring installation rules for

your country. An all-pole disconnection switch having a contact

separation of at least 3mm in all poles should be connected

during installation.

●When the cooker hood is located above an appliance, the

minimum distance between the supporting surface for the cooking

vessels on the hob and the lowest part of the hood shall be at

least 660mm.

●Consult local regulations regarding extraction outlets and ensure

these are complied with. Do not connect the hood to a ventilation

EN

4

or hot air duct containing combustion fumes from burning gas or

other fuels. Confirm that room ventilation is appropriate with the

local authorities.

●The air must not be discharged into a flue that is used for

exhausting fumes from appliances burning gas or other fuels

●The hood may stop working during an electrostatic discharge

(e.g. lightning). This involves no risk of damage. Switch off the

electricity supply to the hood and reconnect after one minute.

●This appliance can be used by children aged from 8 years and

above and persons with reduced physical, sensory or mental

capabilities or lack of experience and knowledge if they have

been given supervision or instruction concerning use of the

appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance. Cleaning and user

maintenance shall not be made by children without supervision.

●This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities, or

lack of experience and knowledge, unless they have been given

supervision or instruction concerning use of the appliance by a

person responsible for their safety.

●Children should be supervised to ensure that they do not play

with the appliance.

●Do not install the appliance outdoors in a damp place or in an

area which may be prone to water leaks such as under or near a

sink unit. In the event of a water leak affecting the appliance, do

not use and contact customer services to arrange for inspection.

Do not use flammable sprays in close vicinity to the appliance. ●

●Please dispose of the packing material carefully. There is a

fire risk if cleaning is not carried out in accordance with the

instructions. Refer to the Care and Maintenance sections carefully

for details on how to clean and replace the aluminium and carbon

filters (if fitted).

●Refer to the Care and Maintenance section for details on the type

of lamps that can be used and how to replace them.

●Do not use a steam cleaner for care and maintenance.

●The appliance is not intended to be operated by means of an

5

external timer or separate remote control system.

●There shall be adequate ventilation of the room when the hood is

used at the same time as appliances burning gas or other fuels.

Ensure that the negative pressure of the installation site does not

exceed 4 Pa (0.04 mbar) to ensure combustion fumes are not

drawn back into the room.

●Do not use the hood if it shows signs of damage or imperfection.

Contact customer services for assistance.

Switch off the appliance at the mains supply before carrying out ●

any maintenance work or cleaning.

●CAUTION: Accessible parts may become hot when used with

cooking appliances.

●Do not flambe under the hood. To avoid the risk of fire, clean

or replace the grease filter regularly and closely monitor pans

containing hot oil.

●The manufacturer declines all liability for personal or material

damage as a result of misuse or incorrect installation of this

appliance.

●The appliance is for domestic use only as an extractor hood.

INSTALLATION INSTRUCTIONS

All installation must be carried out by a competent person or

qualified electrician. Before connecting the mains supply ensure that

the mains voltage corresponds to the voltage on the rating plate.

The appliance must be connected directly to the mains using an

omnipolar circuit breaker with a minimum opening of 3mm between

the contacts.

The installer must ensure that the correct electrical connection has

been made and that it complies with the wiring diagram.

Regularly check the power plug and power cord for damage. If the

supply cord is damaged, it must be replaced by a special cord or

assembly available from the manufacturer or its service agent.

WARNING: This is a Class II appliance and MUST NOT be

earthed.

6

Contents of packaging

Rangehood

(1)

Ø120mm

Ducting adapter

(1)

Chimney (Upper+lower)

(1)

Ø6 x 30mm

Expansion plug

(8)

ST3.9 x 32mm

Screws

(8)

Upper chimney bracket

(1)

Chimney bracket

(1)

ST3.9 x 13mm

Screws

(4)

7

INSTALLATION

Positioning

660mm

top of cooking

surface

Fixing dimensions

WARNING!

these instructions may result in electrical hazards.

700/900/1200

500

52

550

316

286

Min 724/Max 1032

8

●Mark the location for flue cover wall mounting brackets, rangehood

mounting points and anti-tilt fixing points above the rangehood

using the base as the reference point (Fig. 1).

Drilling holes

Fig.1

●Attach the upper hood mounting screws in the locations shown

in Fig.2. Use the ST3.9 x 32 screws and expansion plugs if

attaching to masonry.

Attach chimney brackets and hood mounting screws

9

●Remove the aluminium filters from the rangehood body and hang

it on the ST3.9 x 32mm screws then secure at the anti-tilt locations

as indicated in Fig. 3.

Attached hood on wall

2mm

Fig.2

Fig.3

Screws

ST3.9 x 32mm

10

●Connect Ø120mm ducting adapter to the blower outlet and use

ST3.9 x 13mm screws to fix it to the range hood (Fig. 4).

Connect ducting adapter

Fig.4

●If need exhaust air to the outside.

Connect Ø125 mm flexible duct to the

adapter and fix it (Fig. 5).

Fixing flexible duct

Fig.5

Screws ST3.9 x 13mm

Ø120mm

Ducting adapter

11

Attach the chimney

●Fix the chimney to the top bracket

using the ST3.9 x 13mm screws. Connect top of

the ducting tube to vent kit as per

manufacturers instructions (Fig. 7).

Connect ducting adapter

Fig.6

Fig.7

●Install back the aluminium filters to

rangehood, and for Stainless Steel

appliance, remove the protection

film from rangehood and chimney.

12

OPERATING INSTRUCTIONS

Control panel features

CLEANING AND MAINTENANCE

Warning: always switch off the electricity supply before

carrying out maintenance work on the hood. In the event of a

fault, contact an official distributor or Customer Service.

Exterior Cleaning : Use non-corrosive, liquid detergent and avoid the

use of abrasive cleaning products.

1 – Light switch.

2 – Lighting control lamp.

3 – 3 position switch controls the motor (1st, 2nd, and 3rd speed).

4 – Motor control lamps.

TIMERTo operate the canopy timer, having selected the speed, press

the button for 2 seconds until the luminous LED blinks. The timer will then

work for 15 minutes.

At the end of this time the motor will stop and the light will go out. If it is still

on, and you wish to cancel the timer, press the timer button once and the

motor will stop.

Replacing the lamp

Ensure that the rangehood is unplugged, then slide out the

retractable hood and remove the filters. Turn the lamp anti-clockwise

to remove then replace the lamp by turning it clockwise.

2 4

1 3

Warning: the lighting should not be used as permanent

light source but only for cooking.

Note that lamps become hot when in use. Allow the lamps to

cool down for a few minutes before changing them.

13

from the manufacturer.

≤ 65ºC

1 MONTH

OFF

FUSE

10’

14

Replace Activated charcoal every 3 months

3 MONTHS

Troubleshooting

Problem Possible cause Solution

Excessive vibration. The appliance is not installed

properly on the brackets.

Take down the appliance and check

The fan blade is damaged.

Switch off the appliance. Repair to

personnel only.

The light is on, but the

fan does not work.

The fan blade is jammed.

The motor is damaged.

Both the light and

motor do not work.

Light bulb blown. Replace with a bulb of the

correct rating.

Power connection loose. Check power supply.

Suction

performance reduced.

Speed may be too low. Select a higher speed.

are dirty. Care and maintenance section).

Top vent might be

obstructed.

Clear any obstruction.

Optional vent kit might be twisted. Ensure that the vent kit

manufacturer’s instructions.

The installation may not comply with

the manufacturers instructions.

The vent hose should be correct

diameter throughout with no

reductions or restriction.(See

installation section).

Works normally but

cooking smells linger. recirculation mode or is full

of grease. maintenance section).

Replacing Activated charcoal filters

15

Recycling & disposal

The symbol on the product or on its packaging indicates

that this product may not be treated as household waste.

Instead it shall be handed over to the applicable collection

point for the recycling of electrical and electronic

equipment.

By ensuring this product is disposed of correctly,

you will help prevent potential negative consequences for the

environment and human health, which could otherwise be caused

by inappropriate waste handling of this product.

For more detailed information about recycling of this product, please

contact your local city office, your household waste disposal service

or the shop where you purchased the product.

16

17

●

3

660

18

19

20

Ø120

(1) (8)

(8)

(4)

(1)

Ø6 x 30

ST3.9 x 32

ST3.9 x 13

ページを読み込んでいます...

Philco PC700SNL ユーザーマニュアル

関連論文

その他の書類