2. Kyosho
  3. NISSAN GT-R GT500 2008 Body Aseemble

Kyosho NISSAN GT-R GT500 2008 Body Aseemble ユーザーマニュアル

  • こんにちは！京商 dNaNo FX NISSAN GT-R GT500 2008 ボディ組立キットの取扱説明書を読み終えました。このキットの組み立て方法、必要な工具、塗装方法など、ご不明な点がございましたらお気軽にご質問ください。説明書には、パーツの取り付け順序や、ボディとシャーシの接続方法が丁寧に図解されています。
  • 組み立てに必要な工具は何ですか？
    塗装はいつ行いますか？
    塗装にはどのような塗料を使用しますか？
    ボディとシャーシの接続方法は？
Before beginning assembly, please read these instructions thoroughly.
INSTRUCTION SHEET
No.DNB410
for dNaNo FX Series
NISSAN GT-R GT500 2008
Body Assemble (Non Decoration)
Tools : Must be prepared. *Cutter Knife. *Nippers *Adhesive for plastic *A Phillips Screwdriver
(Precision type or a small sized)
1
Preparation of Chassis
2
Body Assembly
Body
DNB410
-
T01
Window
Front Body Mount Support
Painting should be done before assembling.
Attach each part as required.
For painting. use plastic model paints.
Insert the wheel spacer into the wheel.
Side Body Mount (R)
Side Body Mount (L)
3
Body Assembly
4
Body Mounting
Mount in orderly sequence.
www.kyosho.com
www.dnano.jp
*SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
© Copyright 2010 KYOSHO CORPORATION /
61921011-1 PRINTED IN JAPAN
1 2
3
You may hear a "click" noise.
1
1
2
Insert the section of the body into the
section of the display chassis (as shown
with the outline in the diagram).
Insert the display chassis at an angle of
about 30° to the body.
With the chassis inserted in the groove,
push the display chassis in as shown
in the diagram.
Spread the sides of the body apart
and attach on to the display chassis.
Exhaust Pipe (L)
Side Mirror (L)
Front Grill
Windshield Wiper
Front Hook
Side Spoiler (R)
Side Spoiler (L)
Head Light Base (L)
Head Light Base (R)
Side Plate (L)
Roof
Head Light Shield (L)
Head Light Shield (R)
Rear Wing
Side Mirror (R)
Rear Hook
Exhaust Pipe (R)
Side Plate (R)
L
Tail Light Lens (L)
R
Tail Light Lens (R)
Antenna
/