English
Introduction
When the Privacy Filter is installed on a notebook, the viewing angle is
narrowed to about 60°, obscuring the screen from the left and right sides.
Although the screen becomes hard to see from the left and right sides, it
remains clearly visible from the front. The enhanced privacy resulting from
obscuring the screen from prying eyes lets you use your notebook without
having to worry about your location.
Notes
• The Privacy Filter is specially designed for Sony VAIO notebooks. It may
not be usable with all models, so make sure that it is compatible with
your notebook before using it.
• The Privacy Filter works properly even if it is warped.
Precautions for Use
Observe the following precautions. If you experience problems using the
Privacy Filter, refer to the manuals provided with your notebook for
information about support from Sony.
Installation Location
Avoid the following locations:
• Where corrosive gases may be present
• Where high temperatures may occur, such as in directly sunlight or near
a heat source
• Where temperature may change abruptly
•Where high humidity or dust is present
Specifications
Operating temperature
41˚F to 95˚F (5˚C to 35˚C)
(temperature gradient less than 18˚F (10˚C)/hour)
Storage temperature
–4˚F to 140˚F (–20˚C to 60˚C)
(temperature gradient less than 18˚F (10˚C)/hour)
Dimensions
Approx. 9.2 × 5.6 inches (232 × 140 mm) (w/h)
Mass Approx. 0.8 oz. (22 g)
Supplied accessories
Operating instructions (1)
Stickers (10, 1 sheet)
Design and specifications are subject to change without notice.
Viewing angle with the
Privacy Filter (approx. 60°)
Viewing angle without
the Privacy Filter
Installation
Notes
• When subject to strong shock, the LCD may break, which can cause
injury. When attaching the Privacy Filter, do not exert strong force.
• When attaching the Privacy Filter, take care not to cut yourself on its
edges.
1 Clean the notebook‘s LCD by wiping it with a soft, dry
cloth.
2 Peel the protective covers away from the front and rear
surfaces of the Privacy Filter.
z Hint
If the protective covers do not peel away easily, try rubbing a piece of generic
adhesive tape at a corner to start separating the cover.
3 Fit the Privacy Filter into the notch at the top of the display.
The top of the Privacy Filter is the long edge with three projections.
4 Bend the Privacy Filter and fit the projections at the bottom
into the notches at the bottom of the display.
Privacy Filter
(edge view)
Protective
cover
Top
Bottom
z Hints
• You can remove fingerprints from the Privacy Filter by wiping it with a dry
cloth or moist tissue.
• Do not use solvents, cleaning alcohol, benzine or other substances that may
damage the Privacy Filter.
• Depending on the temperature and humidity at the time of use, the Privacy
Filter may warp or bend somewhat. This will not affect the filter’s
performance, however.
• If the Privacy Filter does not hold securely to the display, causing it to skew or
fall, use the supplied stickers to secure it to the display.
Removal
Insert your fingernails in the spaces at the left and right edges of the Privacy
Filter, and remove it carefully as illustrated.
Notes
• When removing the Privacy Filter, be careful to avoid damaging the notebook
display or the filter.
• When storing the Privacy Filter, be careful to protect it from damage.
Identification of the Front,
Rear, Top and Bottom of the
Privacy Filter
The front and rear surfaces, and the top and bottom edges of the Privacy
Filter can be identified as follows:
Front: Matte surface
Rear: Glossy surface
Top: Three projections located at each end and the middle of the edge
Bottom: Two projections located at each end of the edge (none in the
middle of the edge)
Top edge
Bottom edge
• Sony, VAIO, and are trademarks of Sony Corporation.