Instruction Manual
FH9701
www .origin.hk
Read all instructions carefully before using the FAN HEATER, and keep this
instruction for furture reference when necessary.
This instruction manual can be acquired at www.origin.hk.
*
**
*
**
Ceramic Heater
Important Safety Information
Ceramic Heater
1
The Heater is not intended to be operated
by means of an external programmer,
timer,seperate remote-control system or
any other device that switches the Heater
on automatically, since a fire risk exists if
Heater is covered or positioned incorrectly.
Read all instructions carefully before using the
Heater.
If the supply cord is damaged, it must be
replaced by manufacturer, its service agent or
similary qualified persons in order to avoid a
hazard.
(
)1
WARNING: In order to avoid over heating,
do not cover the Heater. The Heater is hot
when in use. To avoid burns, do not let
bare skin touch hot surface.
(
)
The Heater must NOT be used in
potentially dangerous location such as
flammable explosive, chemicalladen
or wet atmospheres.
WARNING: To reduce the risk of fire, keep
textiles, curtains, or any other flammable
material a minimum distance of 1m from
the air outlet and inlet of the Heater.
WARNING: Do not use this Heater in small
rooms when they are occupied by persons not
capable of leaving the room on their own,
unless constant supervision is provided.
Do not use this Heater if it has been dropped.
Do not use if there are visible signs of
damage to the Heater.
Use this Heater on a horizontal and stable surface.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible or their safety.
Children should be supervised to ensure that
they do not play with the appliance.
Heater is intended for household use
ONLY, not for industrial or outdoor use.
The Heater must not be located
immediately below a socket outlet.
Important Safety Information
Ceramic Heater
2
WARNING: To avoid danger of electric
shock, unplug from outlet when not in
use and before cleaning.
The Heater includes an audible alarm to
warn when the Heater are overheat. If
the alarm sounds, immediately turn the
Heater off and inspect the Heater. DO
NOT OPERATE THE HEATER WITH THE
ALARM SOUNDING!
The Heater is not intended for use in
the immediate surroundings of a basin,
a bath, a shower, a swimming pool, a
wet or damp locations.
()
This product contains recyclable
materials. Do not dispose this
product as unsorted municipal
waste. Please contact your local
municipality for the nearest
collection point.
220-240V~ 50-60Hz
Before using the Heater, check if the
voltage marked on the rating label
corresponds to the mains in your home.
Remove the package and ensure that the
Heater is undamaged. In case of doubt
do not use the Heater and contact your
supplier.
Do not pull the power cord to disconnect
with power source. Always grasp the plug
to pull out.
Avoid using extension cord as the
extension cord may overheat and casue fire.
Do not insert any objects into the Heater
as it may cause an electric shock or fire
or damage to the Heater. Do not block
or tamper with the Heater in any manner
while it is in operation. To prevent
a possible fire, do not block air inlet
or oultet in any manner. Do not place on
soft surfaces, like a bed, where opening
may become blocked.
WARNING: The Main Power Switch and the
On/Off switch should not be used as the
sole means of disconnecting power.
Do not let children play parts of package.
Main Parts
Ceramic Heater
3
BACK
FRONT
Power Cord
Plug
/
Main Power
Switch
The picture is for
reference only,
everything in kind
shall prevail.
Air Outlet
Base
Control Panel
ECO Sensor
Air Inlet
Handle
LED
LED Display
Function Setting
Ceramic Heater
4
1.
2.
3. /220-240V
/
The Heater may be operated by the manual controls located on the Heater.
1. Carefully remove the Heater from the plastic bag and the carton.
2. Place the Heater on a stable flat surface.
3. Set the Main Power Switch to 'OFF' position. Plug the Power Cord into a
a.c. 220-240V electrical outlet. Turn the Main Power Switch to 'ON'
position. the Heater will have a "beep" sound", then the Heater is ready
to use and show the current room temperature.
NOTE: For first time operation, there will have some smell for about few
minutes. Because this Heater have some protective oil on the surface
of the heating.
5.
30 2
30
5. MODE: Press the" "key, the Heater will work in sensor mode. Sensor
will detect any body movement about 30 degree of the Left/Right
direction and in front of it within 2 meter. If no body movement
is detected or 2 minutes, the Heater will stop working after 30
seconds. The Heater will work again whenever it detects any
body movement. When using the sensor mode, the timer
and oscillation function cannot be used at the same time.
4. ON/OFF: Press the" "key, the Heater will start operation at Low Heat,
(1200W)‘Lo’ indicator will light on. Press the" "key to set
the Heater into High Heat(2000W).
4. (1200W).‘Lo’
(2000W)
Function Setting
Ceramic Heater
5
7. 81-8
8. " "
8. OSC : Press the" "key will allow the Heater to oscillate the wind
direction. To stop the oscillation, press this key again.
*** Note: When the Heater is tipped over, the tipping device makes a
sound, which is a normal phenomenon.
*** :
7. TIMER: Press" "key continually to set desired auto power off time.
There are 8 time intervals (1-8 hour), for auto power off.
The timer setting is displayed on the display.
9. " "
30/
9. OFF: To turn the Heater off, press the" "key. The FAN will work for 30
seconds to cool down the Heater and then turn OFF, then set the
Main Power Switch to 'OFF' position.
6. LED
241(
19-42)5
6.1.
6.2.
6. Temperature Setting: In the working mode, press and hold" "key for 3
seconds to enter the temperature setting mode, and the LED will display
the preset temperature"24 or the latest set tem perature. Press " "
key each time toincrease 1 (Adjustable temperature ran ge: 19-42).
After the setting is completed, the display will flash for 5 seconds, and
then the LED will automatically return to display the current ambient
temperature.
6.1. When the ambient temperature is equal or above of the set
temperature, the Heater stops heating.
6.2. When the ambient temperature is below the set temperature, the
Heater resumes heating with the set power.
Safety Features
Maintenance
Ceramic Heater
1. A thermal overload protector is built-in to prevent overheating.
2. When the Heater is overheat, it will be shut off automatically. To RESET
the Heater:
2.1. Unplug the Heater and wait for 30 minutes to cool down.
2.2. Turn ON the Heater again to resume operation.
1.
2.
2.1. 30
2.2.
6
WARNING: ALWAYS UNPLUG THE POWER CORD BEFORE MOVING OR
SERVICING. DO NOT IMMERSE THE HEATER IN WATER! MAKE
SURE THE HEATER IS COMPLETELY COOL DOWN BEFORE CLEANING
CLEANING: Clean the Air Inlet with the vacuum brush attachment on your
vacuum cleaner. Clean the body of the Heater with a soft cloth.
If the Heater is used frequently, the activated carbon filter
needs to be cleaned every month.
CAUTION: Do NOT use gasoline, benzene, thinner, harsh cleaners, etc., as
they will damage the Heater. NEVER use ALCOHOL or any other
SOLVENTS.
STORAGE: Store the Heater with these instructions in the original box in a
cool and dry place.E THE HEATER IN WATER!
( )
:
: FH9701
www.origo.hk
Item : Ceramic Heater
Model : FH9701
www.origo.hk
Warranty Card(1 year carry-in)
(3):
1. /
2.
- /
- /
-
3.
4.
5.
6.
*** 3 : 10 3 15
( ) : www.origo.hk
403(12)21H
: 2156 8238
www.origo.hk
This product is warranted for 1year (commercial use for 3 months) from the date of purchase
under the following conditions:
1. For any defect, in the judgment of our technician, if it is caused under normal use, we are
responsible for repairing the product, and/or replacing parts at free of charge.
2. This warranty DOES NOT apply to:
- If the product has been damaged through abuse, misuse, negligence or accidents;
- Unauthorized repair, alteration/modification;
- The housing, cover or accessories, is excluded from this warranty.
3. The customer is requested to bring the unit to and from our Service Centre whenever
service is needed.
4. Any defective parts, which had been replaced, shall be of our property.
5. This warranty is valid in H.K.S.A.R. only.
6. Please show the Invoice to get free service.
***Extra 3 months warranty: just complete Online Warranty Registration within 10 days from
the date of receipt, free warranty will be extended to 15 months (not applicable to commercial
use). Plaese enter our website: www.origo.hk
Service Centre
ORIGIN MARKETING LIMITED
Unit H, 21/F., Reason Group Tower (nearby 12 Wah Sing Street),
403 Castle Peak Road, Kwai Chung, N.T., Hong Kong.
Tel: 2156 8238
Ceramic Heater
/
