This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
$Q\FKDQJHVRUPRGLƮFDWLRQVQRWH[SUHVVO\DSSURYHGE\WKHSDUW\UHVSRQVLEOHIRUFRPSOLDQFHFRXOGYRLGWKHXVHUoVDXWKRULW\
to operate the equipment.
FCC STATEMENT
Frequently Asked Questions (FAQ)
The Power LED should be lit when the power system is working normally.
If the Power LED is not lit, please check as follows:
A1:
Make sure the power cord is connected to the switch with power
source properly.
A2:
Make sure the voltage of the power supply meets the requirements
of the input voltage of the switch.
A3: Make sure the power source is ON.
Q1. The Power LED is not lit.
It is recommended that you check the following items:
A1:
0DNHVXUHWKDWWKHFDEOHFRQQHFWRUVDUHƮUPO\SOXJJHGLQWRWKH
switch and the device.
A2
:
Make sure the connected device is turned on and working well.
A3
:
The cable must be less than 100 meters long (328 feet).
Q2. The Link/Act LED is not lit when a device is connected
to the corresponding port.
6SHFLƮFDWLRQV
This is a class B product. In a domestic
environment, this product may cause radio
interference, in which case the user may
be required to take adequate measures.
CE Mark Warning
Do not use this product near water,
for example, in a wet basement or
near a swimming pool.
Avoid using this product during an
electrical storm. There may be a
remote risk of electric shock from
lightning.
SAFETY NOTICES
Cautions
Industry Canada Statement
CAN ICES-3 (B)/NMB-3(B)
Explanation of the symbols on the product label
DC voltage
RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic equipment
(WEEE). This means that this product must be handled pursuant to European directive
2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling organization or to the retailer
when he buys a new electrical or electronic equipment.
Use only power supplies
which are provided by
manufacturer and in the original
packing of this product.
Safety Information
For technical support and other information, please visit
https://www.tp-link.com/support, or simply scan the QR code.
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant
provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.
The original EU declaration of conformity may be found at http://www.tp-link.com/en/ce
BSMI Notice
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
0ťC to 40ťC (32ťF to 104ťF)
-40ťC to 70ťC (-40ťF to 158ťF)
10% to 90%RH non-condensing
5% to 90%RH non-condensing
(QYLURQPHQWDODQG3K\VLFDO6SHFLƮFDWLRQV
IEEE 802.3, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x
CSMA/CD
5/8/16/24 10/100Mbps Auto-Negotiation RJ45 Ports
%$6(7873FDWHJRU\FDEOHƩP
EIA/TIA-568 100
Ƴ
673ƩP
%$6(7;873FDWHJRU\HFDEOHƩP
EIA/TIA-568 100
Ƴ
673ƩP
Power, Link/Act LEDs
Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex)
Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full
Duplex)
Store-and-Forward
Automatically learning, automatically aging
10Base-T: 14881pps/Port
100Base-Tx: 148810pps/Port
Standard
Protocol
Interface
Network Media (Cable)
LED Indicators
Data Transfer Rate
Transfer Method
MAC Address Learning
Frame Forward Rate
*HQHUDO6SHFLƮFDWLRQV
Wall Mountable
Distance Between
Mounting Holes
TL-SF1016D: 157.2mm
TL-SF1024M: 178mm
TL-SF1005D, TL-SF1008D: No
TL-SF1016D, TL-SF1024M: Yes