Connection
©2018 TP-Link 7106508151 REV15.0.1
Installation Guide
10/100Mbps Desktop Switch
For simplicity, we will take TL-SF1005D for example throughout this Guide.
Ethernet Ports (1-5) Power Cord
PC
PC
Router
LAN PortWAN Port
Internet
TL-SF1005D/TL-SF1008D
TL-SF1016D/TL-SF1024M
LED Explanation
Power
On: Power on
O: Power o
Link/Act
On: Link present but no activity
Flashing: Transmitting/receiving data
O: No link
Package Contents: Switch, Power Adapter and Installation Guide.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
FCC STATEMENT
Frequently Asked Questions (FAQ)
The Power LED should be lit when the power system is working normally.
If the Power LED is not lit, please check as follows:
A1:
Make sure the power cord is connected to the switch with power
source properly.
A2:
Make sure the voltage of the power supply meets the requirements
of the input voltage of the switch.
A3: Make sure the power source is ON.
Q1. The Power LED is not lit.
It is recommended that you check the following items:
A1:
Make sure that the cable connectors are rmly plugged into the
switch and the device.
A2
:
Make sure the connected device is turned on and working well.
A3
:
The cable must be less than 100 meters long (328 feet).
Q2. The Link/Act LED is not lit when a device is connected
to the corresponding port.
Specications
This is a class B product. In a domestic
environment, this product may cause radio
interference, in which case the user may
be required to take adequate measures.
CE Mark Warning
Do not use this product near water,
for example, in a wet basement or
near a swimming pool.
Avoid using this product during an
electrical storm. There may be a
remote risk of electric shock from
lightning.
SAFETY NOTICES
Cautions
Industry Canada Statement
CAN ICES-3 (B)/NMB-3(B)
Explanation of the symbols on the product label
DC voltage
RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic equipment
(WEEE). This means that this product must be handled pursuant to European directive
2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling organization or to the retailer
when he buys a new electrical or electronic equipment.
Use only power supplies
which are provided by
manufacturer and in the original
packing of this product.
Safety Information
For technical support and other information, please visit
http://www.tp-link.com/support, or simply scan the QR code.
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant
provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.
The original EU declaration of conformity may be found at http://www.tp-link.com/en/ce
BSMI Notice
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
0˚C to 40˚C (32˚F to 104˚F)
-40˚C to 70˚C (-40˚F to 158˚F)
10% to 90%RH non-condensing
5% to 90%RH non-condensing
Environmental and Physical Specications
IEEE 802.3, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x
CSMA/CD
5/8/16/24 10/100Mbps Auto-Negotiation RJ45 Ports
10BASE-T: UTP category 3, 4, 5 cable (≤100m)
EIA/TIA-568 100
Ω
STP (≤100m)
100BASE-TX: UTP category 5, 5e cable (≤100m)
EIA/TIA-568 100
Ω
STP (≤100m)
Power, Link/Act LEDs
Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex)
Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full
Duplex)
Store-and-Forward
Automatically learning, automatically aging
10Base-T: 14880pps/Port
100Base-Tx: 148800pps/Port
Standard
Protocol
Interface
Network Media (Cable)
LED Indicators
Data Transfer Rate
Transfer Method
MAC Address Learning
Frame Forward Rate
General Specications
Wall Mountable
Distance Between
Mounting Holes
TL-SF1016D: 157.2mm
TL-SF1024M: 178mm
TL-SF1005D, TL-SF1008D: No
TL-SF1016D, TL-SF1024M: Yes
-
1
-
2
TP-LINK TL-SF1008D ユーザーマニュアル
- カテゴリー
- ネットワークスイッチ
- タイプ
- ユーザーマニュアル
他の言語で
- English: TP-LINK TL-SF1008D User manual
関連論文
-
TP-LINK TL-SG116 取扱説明書
-
TP-LINK TL-SG1005D インストールガイド
-
TP-LINK T1500G-8T インストールガイド
-
TP-LINK TL-SF1016D インストールガイド
-
-
TP-LINK MC220L Quick Installation Guide
-
-
TP-LINK UE200 ユーザーガイド
-
-
