Read the manual and follow the directions.

Use of product other than as described in this manual

may cause accident.

Use only for measuring.

Use for any purpose other than measuring may

damage or wear the instrument. Improper use may

also cause accident.

Handle with Care.

Do not drop or subject instrument to excessive shock.

Probe Tip is Sharp-Handle With Care.

Tip can cause injury.

Remove any dirt or rustproofing from the measuring

surfaces and moving parts before use. Make sure the

hardware is tight and secure.

Improper preparation may cause measurement errors.

Use and store only in environment meeting the

following conditions:

Dry location protected from rain, water, and oils.

Location that is not excessively hot.

Location protected from use by children and

unauthorized people.

Use in places contrary to the above may cause damage

to the product resulting in accident or injury.

Do not disassemble or modify.

WARNING

To prevent harm to yourself or others, and to prevent damage to

property, always follow the procedures marked by the following

symbols.

Denotes a prohibition –

For safe and proper use, please read this instruction manual before use and follow the procedures described. Please keep manual

where it is accessible to user for future reference.

Keep this manual with the instrument if transferred or leased to a third party.

For inquiries about this product, please contact dealer or Niigata Seiki.

After use, wipe off any dirt or oil from measuring surfaces, sliding

surfaces, and exterior using a dry cloth and perform rust

Store in a cool, dry, and dark location in the provided case

Keep out of direct sunlight and moisture, and please keep secure

AFTER USE CARESTORAGE

and slide the tip down for good contact.

Gauge is ready for measurement when

the display reads "0.00 mm"

make contact with the surface you want

surface for comparison, and the difference

in height with the reference will be

tilted when making measurements.

Reference

Surface