Install the stainless base plate onto the braze-on
on the seat-tube.
You can install it together with the bottle cage.
PHS-1
Extend the leg and fully insert into the arm with
the red soft plastic bush.
Wrap both the rear wheel and
seat-tube with the Velcro strap
so the bike doesn't move when
parked.
●
●
●
●
●
●
●
● A braze-on is required for the stand to be installed
properly.
● Use on flat and level floor or ground. Do not use on any
slanted location.
● Leg size is adjustable in 20mm travel. Depends on the
braze-on height, you may not be able to use PHS-1.
● Do not get on the bike or apply any load to the bike
when using the PHS-1. The leg should be broken.
● Wrap the rear wheel and frame with the supplied Velcro
strap for stability.
● When storing PHS-1 on the frame, tighten the Velcro
tape firmly. If you need to hold on a vertical pipe due to
some reasons, you should put it above the bottle cage
to prevent dropping down.
● Do not ride with the PHS-1 extended.
PHS-1
Bike Rest Model : PHS-1 ‒ instructions manual
When folding the leg, you must pull apart the mid section first.
Failure to do so will cause too much tension on the inside shock cord.
You can micro adjust the stand angle and the leg length to expect better stability
of the bike when parked.
To adjust the leg length, loosen the small screw by 2mm hex wrench then slide
the leg. Adjustment travel is approximately 20mm.
After adjusting, tighten the screw again.
Do not overtighten. Leg material is fragile.
store you purchased the product or the distributor
in your country. If your question remains unanswered, then contact us here;
503-2305 1197-1
Phone: (0584) 27-3131 / Fax: (0584) 27-7505
minoura@minoura,jp
Web: www.minoura.jp
MINOURA JAPAN
(for ALL customers)
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone: +81-584-27-3131 / Fax: +81-584-27-7505
Email: [email protected] / Web: www.minoura.jp
462-0062
Phone: (052) 909-6201 / Fax: (052) 909-6212
Web: www.fukaya-sangyo.co.jp
MINOURA North America
(for U.S. residents ONLY)
Phone: 1-510-538-8599 / Fax: 1-510-538-5899
Email: [email protected]
Made in Japan
/
