5
7. Button C2
When the gimbal is set to Tilt Locked or Follow mode, press
and hold the button to switch to the other mode. Release the
button to resume operation. When the gimbal is set to FPV
mode, switch is unavailable.
8. Shutter/Record Button
Press the Shutter/Record button to take a photo or to start or
stop recording a video in camera view. In the touchscreen
settings page, press to go back to camera view.
9. Status LED
Indicates the status of Osmo Pocket. The status LED
indicators are the same as Osmo Pocket. Refer to the Osmo
Pocket User Manual for more information on the status LED
indicators.
10. Joystick Control Switch
Toggle the switch to change joystick control mode. Choose
between 360° control and up, down, left, and right control.
11. Button R
Press to change the orientation of the camera between
forward and backward (sele). When Osmo Pocket is not in
FPV mode, hold the button to lock the current attitude of the
gimbal and release the button to unlock.
12. Power/Function Button
Press and hold the Power/Function button for one second
to power on or off. In camera view, press the Power/
Function button to switch between Video and Photo mode
(not available in Pro settings on DJI Mimo). Press the button
twice to recenter the gimbal. In the touchscreen settings
page, press the button to go back to the previous menu.
13. Lanyard Hole
14. 1/4” Mounting Hole
Installation is shown in Figure B. The wireless module,
mobile phone, and Osmo Pocket are not included.
When powered on, Osmo Pocket can charge the
extension rod automatically when they are connected.
If the extension rod is not being used for more than
six months, the built-in battery may run out of power. If
this happens, connect Osmo Pocket to the extension
rod to charge.
Safety Guidelines
1. DO NOT allow the product to come into contact with any
kind of liquid. DO NOT leave product out in the rain or near
a source of moisture. DO NOT drop the product into water.
If the inside of the battery comes into contact with water,
chemical decomposition may occur, potentially resulting
in the battery catching on fire, and may even lead to an
explosion.
2. Put out any product re using water, sand, re blanket or a
dry powder re extinguisher.
3. The product should be used in temperatures from 0 to
40℃. Use of the product in environments above 40℃ can
lead to a re or explosion. Use of product below 0℃ can
lead to permanent damage.
4. Never disassemble or pierce the product in any way or the
battery may leak, catch re, or explode.
5. DO NOT drop or strike the product. DO NOT place heavy
objects on the product.
6. DO NOT heat the product. DO NOT put the product in a