R
THE FINEST RADIO CONTROL MODELS
INSTRUCTION SHEET
Before beginning assembly, please read these instructions thoroughly.
1
Joint A
(30 Size)
(50 Size)
Joint B
x 6 x 36 x 6
x 36
x 6
x 90
x 96
(30 Size)
(50 Size)
x 90
x 96
x 6
Contents
Assembly
Joint A
Circuit Barrier
Mat
Joint B
50 Size only
Note direction
Note direction
Note direction
Do not over tighten
Do not over tighten
Do not over tighten
Mats have a smooth surface on one side, and a rougher surface on the other. The rough surface
produces better grip. Decide which surface you will use, and then assemble as per the steps below.
MINI-Z Grand Prix Circuit 30 Short 48pcs. (30 Size)
MINI-Z Grand Prix Circuit 50 Short 48pcs. (50 Size)
50 Size only
< >< > < >Mats (3 types)
This mark is only for 50 size.
Circuit Barrier (3 types) Joint (2 types)
1.
2.
3.
4.
5.
Insert Joint B from the underside of the mat.
Attach circuit barriers to Joint B.
Insert Joint A from the top. (Do not over tighten)
After attaching all the circuit barriers, refer to the race circuit layouts and lay mats accordingly.
After laying out the race circuit, make sure there is no unevenness where mats are joined.
A
B
A
B
2
1.
2.
3.
4.
5.
B
B
A
< >< > < > 3 3 2
2
www.kyosho.com
R
THE FINEST RADIO CONTROL MODELS
Race Circuit Layout
Precautions
Circuit barriers are designed to prevent cars from leaving the racetrack under most circumstances, however caution should still be exercised.
Do not modify or rest heavy objects on top of the race circuit.
Avoid using or storing the race circuit in high temperatures or humidity as this may cause damage or deformation.
© 2015 KYOSHO CORPORATION
*SPECIFICATIONS ARE SUBJECT TO BE CHANGED WITHOUT NOTICE.
/