4
Warranty and repair
If there is any problem with your remote control hardware, please keep the proof of purchase and contact
the retailer where you purchased the TX12. You may also visit our warranty support page https://
www.radiomas-terrc.com/contact
Firmware update and OpenTX
For the latest information and firmware updates from the OpenTX open source firmware development team,
please visit the OpenTX website at https://www.open-tx.org.
EU Simple Declaration of Conformity
RadioMaster declares the radio equipment TX16s is in compliance with EU directives Directive
2014/53/EU. Full text of the declaration of conformity is available at the following website www.radio-
masterrc.com
Manufacturer by
ShenZhen RadioMaster Co., Ltd
5th Floor, Yutian Building, No. 18 Yangtian Road, Xin’an Street, Baoan District, Shenzhen, Guangdong.
FCC ID: 2AV3G-TX12
FCC Information
This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. Full text of
the declaration of conformity is available at the following website www.radiomasterrc.com
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment. This product contains a radio transmitter with
wireless technology which has been tested and found to be compliant with the applicable
regulations governing a radio transmitter in the 2.400GHz to 2.4835GHz frequency range.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
The device should be suitable for general population/uncontrolled exposure limits, which
average 1.6 W/kg in any 10 g tissue. The maximum SAR test result is 0.407W/kg. The test
distance is 0mm. In order to meet the RF exposure requirements, the minimum distance
between the user's limbs and the remote control (including the antenna) is 0mm.