Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES.” These sections provide important information concerning the proper operation
of the unit.
The manual should be saved and kept on hand as a convenient reference.
WIRELESS USB ADAPTER
Blinking: The adapter is searching for a network.
Lit: The adapter is connected to a network.
Function indicator LED
Main Specications
NETGEAR WNA1100: WIRELESS USB ADAPTER
Interface Hi-Speed USB
Standards IEEE 802.11 b/g/n 2.4 GHz
Transmission speed 150 Mbps (Max)
Power USB Bus powered
Operating products
Roland products equipped with USB interface and wireless
connection features.
* This adapter can connect to wireless access points that support WPS (Wi-
Fi Protected Setup).
* Before disconnecting the WNA1100 from your device, follow the
instructions in the owner’s manual of your device to ensure that the
WNA1100 can be disconnected safely.
* In the interest of product improvement, the specications and/or
appearance of this unit are subject to change without prior notice.
* Roland is a registered trademark of Roland Corporation in the United
States and/or other countries.
* Company names and product names appearing in this document are
registered trademarks or trademarks of their respective owners.
* NETGEAR is a registered trademark of NETGEAR, Inc.
This product can be used with Roland products that support wireless connectivity.
For details on how to connect to your network, refer to the owner’s manual of your compatible product or to the PDF le of the owner’s manual provided on the Roland website.
Information about Roland products that are compatible with this product and PDF les of the owner’s manuals for them can be obtained from the Roland website below.
http://www.roland.com/
Owner’s Manual
WNA1100
* 5 1 0 0 0 2 8 3 8 9 - 0 2 *
WARNING
Do not disassemble or modify by yourself
Do not open or perform any internal modications
on the unit.
Do not repair or replace parts by yourself
Do not attempt to repair the unit, or replace parts
within it (except when this manual provides specic
instructions directing you to do so). Refer all
servicing to your retailer, the nearest Roland Service
Center, or an authorized Roland distributor, as listed
on the “Information” page.
Do not use or store in the following types of locations
• Subject to temperature extremes (e.g., direct
sunlight in an enclosed vehicle, near a heating
duct, on top of heat-generating equipment); or are
• Damp (e.g., baths, washrooms, on wet oors); or are
• Exposed to steam or smoke; or are
• Subject to salt exposure; or are
• Humid; or are
• Exposed to rain; or are
• Dusty or sandy; or are
• Subject to high levels of vibration and shakiness.
WARNING
Do not allow foreign objects to enter the unit or liquids to
contact the unit
Never allow foreign objects to enter the unit, or
liquids (such as water or juice) to contact the unit.
Adults must provide supervision in places where children
are present
When using the unit in locations where children are
present, be careful so no mishandling of the unit
can take place. An adult should always be on hand
to provide supervision and guidance.
CAUTION
Do not step on or place weight on unit
Never step on the unit or place heavy objects on it.
USING THE UNIT SAFELY IMPORTANT NOTES
Copyright © 2012 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written
permission of ROLAND CORPORATION.
• Do not expose the unit to direct sunlight, place
it near devices that radiate heat, leave it inside
an enclosed vehicle, or otherwise subject it to
temperature extremes. Excessive heat can deform
or discolor the unit.
• When moved from one location to another where
the temperature and/or humidity is very dierent,
water droplets (condensation) may form inside
the unit. Damage or malfunction may result if
you attempt to use the unit in this condition.
Therefore, before using the unit, you must allow it
to stand for several hours, until the condensation
has completely evaporated.
• Swiftly wipe away any liquid that spills on the unit
using a dry, soft cloth.
• Use a reasonable amount of care when using
the unit’s connector. Rough handling can lead to
malfunctions.
• Carefully insert the unit all the way in—until it is
rmly in place.
• Never touch the terminals of the unit. Also, avoid
getting the terminals dirty.
• This product is constructed using precision
components; handle the product carefully, paying
particular note to the following.
• To prevent damage to the cards from static
electricity, be sure to discharge any static
electricity from your own body before handling
the products.
• Do not touch or allow metal to come into
contact with the contact portion of the
products.
• Do not bend, drop, or subject products to
strong shock or vibration.
• Do not allow products to become wet.
• Do not disassemble or modify the products.
Caution regarding radio frequency emissions
• The following actions may subject you to penalty of law.
• Disassembling or modifying this device.
• Removing the certication label axed to the back of
this device.
• Do not use this device in a hospital.
Doing so may cause medical equipment to malfunction.
• Do not use this device in an airplane.
Doing so may cause the airplane’s instruments to malfunction.
• Do not use this device closer than 22 cm (8-11/16 inches)
from where a cardiac pacemaker is implanted.
Doing so may aect the operation of the cardiac pacemaker.
ページが読み込まれています...
-
1
-
2
他の言語で
- français: Roland WNA1100-RL Le manuel du propriétaire
- English: Roland WNA1100-RL Owner's manual