Sony LMP-H160 ユーザーマニュアル

  • こんにちは!このSonyプロジェクターランプの取扱説明書を読みました。ランプの交換方法や安全上の注意事項、廃棄方法などについてご質問があれば、お気軽にお尋ねください。この説明書には、安全な使用方法や、ランプ交換後の初期設定方法なども詳しく解説されています。
  • ランプ交換後、すぐに「ランプ/フィルターを交換してください」というメッセージが表示される場合、どうすれば良いですか?
    使用済みランプを廃棄する際の注意点は何ですか?
    ランプ交換の際に注意すべきことは何ですか?
Projector Lamp
.........................................
(JP)
Operating Instructions ........................ (GB)
Mode d’emploi .................................... (FR)
Bedienungsanleitung .......................... (DE)
Manual de instrucciones ..................... (ES)
Istruzioni per d’uso ............................. (IT)
......................................... (CS)
3-268-715-01 (1)
1
2007 Sony Corporation Printed in Japan
70 VOC (
)
Printed on 70% or more recycled paper using VOC (Volatile
Organic Compound)-free vegetable oil based ink.
/
1
2
OK
2
English
The projector lamp is designed to be used with the Sony projector. Before
replacing the lamp, read the Operating Instructions of the projector and
make sure that this lamp can be used for your projector.
When you replace the lamp, make sure you replace the air filter attached to
the lamp. Also, clean the ventilation holes (intake) at the same time.
To replace the lamp/air filter, refer to the Operating Instructions of the
projector.
Cautions
The lamp becomes a high temperature after turning off the projector with
the ? / 1 key. If you touch the lamp, you may scald your finger. When
you replace the lamp, wait for at least an hour for the lamp to cool.
When removing the lamp unit, make sure it remains horizontal. If you
pull out the lamp unit while tilted and if the lamp breaks, the pieces may
scatter, causing injury.
Notes
If the lamp breaks, consult with qualified Sony personnel.
Please do the following operations after replacing the lamp with a new
one. If you don’t so, the message “Please replace the Lamp/Filter.” may
appear at once after replacing the lamp.
1 Plug the AC power cord into a wall outlet.
2 Turn on the projector, then select Setup
menu. The following menu
appears.
“Settings for lamp replacement. Has the projection lamp been replaced?”.
Select “Yes”, if this screen appears.
If the message “Lamp replacement process is now complete” appears,
select “OK”.
Disposal of Used Lamp
This projector’s lamp contains mercury and should be disposed of properly.
Consult your local authorities regarding safe disposal. The material
contained in this lamp are similar to those of a fluorescent lamp, so you
should dispose of it in the same way.
For customers in the USA
Lamp in this product contains mercury. Disposal of these materials may be
regulated due to environmental considerations. For disposal or recycling
information, please contact your local authorities or the Electronic
Industries Alliance (www.eiae.org).
For customers in Europe
Disposal of Old Electrical & Electronic Equipment (Applicable
in the European Union and other European countries with
separate collection systems)
This symbol on the product or on its packaging
indicates that this product shall not be treated as
household waste. Instead it shall be handed over to the
applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused
by inappropriate waste handling of this product. The
recycling of materials will help to conserve natural
resources. For more detailed information about
recycling of this product, please contact your local
Civic Office , your household waste disposal service
or the shop where you purchased the product.
Supplied accessories Air filter (2)
Operating Instructions (this manual)
Warranty ceritificate (1)
/