NEXTORCH GT6A-RL ユーザーマニュアル

  • NexTORCH GT6A-RL 懐中電灯の操作マニュアルについて、ご質問にお答えします。このマニュアルには、製品の仕様、使用方法、メンテナンス方法、安全上の注意などが記載されています。どのようなことでもお気軽にご質問ください。
  • バッテリーの充電時間は?
    電球の交換方法は?
    ライトを長く使わない場合はどうすればいいですか?
    ライトの清掃方法は?
R
OPERATOR’S MANUAL
FLASHLIGHT
GT6A-RL
2
Screw off the tailcap.
Insert the battery correctly according to the anode and
cathode indicated on the barrel.
Screw the tailcap back to the barrel.
POLYCARBONATE REFLECTOR
LITHIUM BATTERY
NT18650
RUBBER
TAILCAP
O-RING
O-RING
BRAINPAN
BARREL
1W LUXEON LED
FULL CLEAR GLASS LENS
GT6A-RL FLASHLIGHT FEATURES
Product Model
Bulb
Battery
Material
Lens' Material
Runtime
Dimensions
Weight
Special Features
GT6A-RL
1W LUXEON LED
Max Output 35 Lumens
NT18650 Lithium Battery
Durable Nylon Fibre
Full Clear Glass Lens
Up to 480 Minutes
65g (Battery excluded)
click on tailcap,patented anti-rolling
structure,watertight structure,
compact size,anti-impact housing,
non-conductive surface
Length:124mm
Barrel Diameter: 29mm
Head Diameter: 34mm
Press to switch ON and OFF
Remove the head by rotating the barrel until it is free of
the barrel.Put the replacing lamp assembly back to the
barrel and repert the reverse steps to finish your lamp
replacement.
Put the battery into slot of the charger with right polarity.
1
2
3
Connect the battery slot with the plug.
Insert the plug to the electrical socket .The indicator LED turns on
when charging,it turns red to green when charging completed.
Attention: It takes about 4 hours for charging a single NT18650.
Thank you for choosing NexTORCH
flashlight. It produces
not only brilliant, extraordinary white light, but also a lot of heat.
In case of damaging your flashlight and the things around the
flashlight, please pay attention to the following:
1. Do not put the the head of flashlight straight on the flat,
which would damage the bulb or even cause a fire as the
heat can't release from the flashlight.
2. Do not shine the eyes straight as the powerful light could
cause a permanent injury.
3. Do not dismantle the bulb assembly.
NOTICE
MAINTENANCE
To keep your flashlight always in a perfect condition, follow
the instructions as below.
1. Clean your flashlight with a soft clean cloth (NexTORCH
offers you a professional lens cleaning tool(Item #LC6).
Please check the accessories right after this instruction).
2. Wash the flashlight (make sure the flashlight is well screwed
on and no water can sink in) by clean water after using in
the seawater or causticity liquid, and dry it by hot air.
3.
When the tailcap doesn't rotate smoothly, lay on some silicone
grease on the "O" ring (you can buy the silicon grease
(Item# SL6)in the outdoor shops, most of the hardware
shops or our retail shops that sell the NexTORCH flashlights)
.
4.
Please release the battery and keep them dry and cool
when you wouldn't use the flashlight for a time.
9
NexTORCH guarantees that all products under NexTORCH brand
are free from manufacture defects. NexTORCH will repair or
replace any defective products,Please contact your local dealer
or e-mail to
This warranty excludes the following:
1). Failure of product due to misuse and/or lack of maintenance.
2). Internal water damage.
NexTORCH LIFETIME WARRANTY
NexTORCH 18650 is lithium battery designed specially for
the NexTORCH . With aluminum shell and 2200mAh electronic
capacity, NT18650 can recharge/discharge about 500 times. With
the help of the built-in circuit protection, you can use the flashlight
freely without worrying the damage of over recharge/discharge.
CAUTION!
RISK OF FIRE, AND BURNS. DO NOT DISASSEMBLE;
DO NOT MIX WITH USED OR OTHER BATTERY TYPES.
KEEP AWAY FROM CHILDREN UNDER 9 YEARS OLD.
ABOUT 18650 BATTERY
ACCESSORIES
NexTORCH offers a full range of product accessories
suited for your flashlight.
NT18650 NT123A
TIT12
FT32
RM83
IRF
LT2113
FIR
V30F
AH6
Rechargeable lithium battery
Attack headLED upgrade assembly
Infrared filterAttack head
HolsterGun mount
Infrared filter lens3 colors filter
Lithium battery
10
11
RF/BF/GF U28
DC3
TS7-L TS7-S
V1438
SL6 LC6
V2844
Red/Blue/Green filter lens
Holster
Long rat-tail switch Short rat-tail switch
Lens
Car express charger
Silicone grease Lens cleaner
Holster
PC176
Police cone
RM8
Gun mount
12
索引
GT6A-RL电筒结构 ................13,14
GT6A-RL快速安装指引................15
GT6A-RL电筒具体参数................16
GT6A-RL使用方法 ................17,18
GT6A-RL使用注意事项及保养注意事项 ........19
关于18650可充式锂电池 ...............20
附件 .......................21,22
GT6A-RL 电筒结构
NT18650可充电电池
按钮开关
防水圈
筒身
防水圈
头盖
PC反光杯
镀膜增透玻璃镜片
GT6A-RL 装配图
LUXEON 1W LED
第一步:逆时针旋转拧开尾盖。
第二步:放入电池,注意正确放置正负极。
第三步:拧上尾盖。
按下橡胶尾盖直至听到“滴答”声响,以打开电筒,重复
以上动作,即关闭电筒。
打开/关闭
灯头替换
手持筒身,逆时针方向旋转头盖,直到头盖离开筒身,取
出灯头并放入替换灯头,重复相反步骤,即可成功实现灯头替
换。
为了方便您正确对NT18650电池充电,请遵循以下顺序:
如何充电
注:单节NT18650电池充电时间为4小时。
1
2
3
用插头连接电池仓。
将电池放进充电器电池仓内。(请按照电池仓内正
极标识正确放置电池)
将充电器插脚端插口插入取电接口。充电时,红色
电指示灯点亮。当指示灯从红色变为绿色,充电完成。
感谢您选择了品质卓越的NexTORCH 系列电筒由于电
筒在工作时会散发较大的热量为了避免使您的电筒和物品
造成损失,使用时请注意以下事项:
1. 不要将光线直射入人的眼睛,较强的光线会对眼睛造成
永久性伤害。
2. 灯头不要经常拆解,以免造成反光杯或灯泡损伤。
21
附件
为了满足您对电筒的不同需求,并使电筒得到全面
的维护,我们设计了一系列的配件。请根据您的个人需
要进行选择,如需详细了解附件参数请联系当地或登陆
我们的网站www.nextorch.com。
NT18650 NT123A
TIT12
FT32
RM83
IRF
LT2113
FIR
V30F
AH6
锂锰电池
LED灯头组 攻击头
攻击头 红外滤镜
枪夹 电筒套
红绿蓝滤镜 红外滤镜镜片
可充式锂电池
/