Display
Pluto Non DI_HK
90x127mm
3000 060 99131
The lter may produce smell after being used for a while because of the absorption of indoor
air. Remove the lter and place it where it has direct sunlight and ventilation for several
hours. Re-install and try using it again. If the odor remains, please replace the lter.
Control
Very poor
Mode switch/
Filter reset
Replace the NanoProtect Filter Series 2
(AC0819/AC0820: FY0194, AC0830: FY0293).
Long press the for 3 seconds.
Clean the surface of the lter
every 4 weeks.
Clean the surface of the lter
Power on/o
Maintenance
Good PoorFair
Air quality light
Filter replacement alert
Air quality
Auto Turbo Sleep
顯示
開始使用後的濾網因吸收了室內空氣，可能會產生少許異味。取出過濾網並放置在
陽光直射和通風的地方數小時。重新安裝過濾網，再次嘗試使用。如果仍有異味，
請更換過濾網。
控制
非常差
模式切換/
濾網重設
每 4 週清潔濾網表面
清潔濾網表面 顯示 時，更換濾網
電源開啟/關閉
更換濾網 (AC0819/AC0820: FY0194,
AC0830: FY0293) 後，長按 3 秒
維護
良好 差一般
空氣質素指示燈
濾網更換提示
空氣質素水平
自動 特強 睡眠
Replace lter when display shows
-
1
