Installing Collar
Hex Wrench
Loosen 1 turn of M3x3 set screws.
Phillips Driver
Hex Wrench
MX019
Set Screw M2x8
MX019
MX019
MX019
MX019
1-S02006
Bind Screw M2x6
1-S02006
1-S02006
1-S02006
1.5
mm
0.9
mm
Do not over tighten!
Note direction
Replace collar and put back
upper arm.
MX019
MX019
TP Button Head Screw Pin 1.4x15mm
MX007
Bind Screw M2x12
MX007
MX007
MXW002R
Collar 4x4mm
MXW002R
Collar 4x8mm
MX007
Bind Screw M2x18
Remove 4 lower links as shown in the figure.
R
THE FINEST RADIO CONTROL MODELS
INSTRUCTION SHEET
No.MXW002R
1
for MINI-Z 4x4 Series WB120mm
Aluminum Link Rod Set (WB120mm)
2
Before beginning assembly, please read these instructions thoroughly!
Before installation, please carefully read and follow the instructions on this
sheet in conjunction with the instruction manual in your MINI-Z 4x4 Series.
Tools required
81852006-1 PRINTED IN JAPAN
243 -0021
046-229-4115
13001800
© Copyright 2020 KYOSHO CORPORATION /
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
www.kyosho.com
Hex Wrench
MX007
MX017
MX007
MX007
6mm
Remove and assemble as shown in the instruction.
MXW002R
Set Screw M2x12
MXW002R
Link Rod 3x21.7mm
MXW002R
Link Rod 3x23.7mm
S x2
x8
L x2
0.9
mm
1-S02006
Drive shaft is returned as shown in the figure.
Align 3 grooves.
Front
Long
Short
MX019
Set Screw
MX019
MX019
MX019
Hex Wrench
0.9
mm
Hex Wrench
x4
1.5
mm
MX019
Align both ends to each other.
Install 4 lower links are put together as shown in the figure.
Screw in the set screw while pressing the
part shown above with needle-nose pliers.
Tighten 1 turn of M3x3 set screws, after inserting pins.
3
4
/