Hex Wrench
Remove 4 lower links as shown in the figure.
Loosen 1 turn of M3x3 set screws.
Note direction
Replace collar and put back
upper arm.
Phillips Driver
Hex Wrench
MX019
Set Screw M2x8
MX019
MX019
MX019
MX019
MX019
1-S02006
Bind Screw M2x6
MX007
Bind Screw M2x12
MX007
MXW001R
Collar 4x2mm
1-S02006
1-S02006
1-S02006
Installing Collar
1.5
mm
0.9
mm
Do not over tighten!
MX019
TP Button Head Screw Pin 1.4x15mm
R
THE FINEST RADIO CONTROL MODELS
INSTRUCTION SHEET
No.MXW001R
Before installation, please carefully read and follow the instructions on this
sheet in conjunction with the instruction manual in your MINI-Z 4x4 Series.
Tools required
1
for MINI-Z 4x4 Series WB110mm
Aluminum Link Rod Set (WB110mm)
2
Before beginning assembly, please read these instructions thoroughly!
Align both ends to each other.
Drive shaft is returned as shown in the figure.
Align 3 grooves.
Front
Short
Hex Wrench
MX007
MX017
MX007
MX007
6mm
Remove and assemble as shown in the instruction.
Install 4 lower links are put together as shown in the figure.
MXW001R
Set Screw M2x12
MXW001R
Link Rod 3x15.8mm
MXW001R
Link Rod 3x19.7mm
S x2
x8
L x2
Long
MX019
Set Screw
MX019
MX019
MX019
Hex Wrench
Screw in the set screw while pressing the
part shown above with needle-nose pliers.
Hex Wrench
Tighten 1 turn of M3x3 set screws, after inserting pins.
1-S02006
MX019
0.9
mm
0.9
mm
1.5
mm
x4
3
4
81852006-1 PRINTED IN JAPAN
243 -0021
046-229-4115
13001800
© Copyright 2020 KYOSHO CORPORATION /
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
www.kyosho.com
/