English 5
Table 1: Suggested tone control settings for different acoustical environments
loudspeaker for correct vertical alignment. On the
base of the loudspeaker is a 3/8” UNC threaded
hole compatible with a standard microphone
stand. On the rear there are threaded holes for
Omnimount
®
brackets.
Operating Environment
These loudspeakers are designed for indoor
use only. The permissible ambient temperature
is 15-35 degrees Celsius (50-95°F) and relative
humidity 20% to 80% (non-condensing). When
the product has been stored or transported in cool
environment and is taken into a warm room, wait
0.5-1 hours before opening any packing to prevent
condensation of humidity before connecting to
mains power.
Maintenance
No user serviceable parts are to be found within
the amplier unit. Any maintenance or repair of
the unit should only be undertaken by qualied
service personnel.
Safety considerations
Although the G One has been designed in
accordance with international safety standards,
the following warnings and cautions should be
observed to ensure safe operation and to maintain
the loudspeaker under safe operating conditions:
• Servicing and adjustment must only be
performed by qualified service personnel.
• The loudspeaker must not be opened.
• Do not expose the loudspeaker to water or
moisture. Do not place any objects filled with
liquid, such as vases on the loudspeaker or
near it.
• This loudspeaker is capable of producing
sound pressure levels in excess of 85dB, which
may cause permanent hearing damage.
• Free flow of air behind the loudspeaker is
necessary to maintain sufficient cooling. Do not
obstruct airflow around the loudspeaker.
• Note that the amplifier is not completely
disconnected from the AC mains service
unless the mains power cord is removed from
the amplifier or the mains outlet.
Guarantee
The G One is guaranteed for a period of two years
against faults in materials or workmanship. Refer to
supplier for full sales and guarantee terms.
Compliance to FCC rules
This device complies with part 15 of the FCC
Rules. Operation is subject to the followinG One
conditions:
This device may not cause harmful interference, and
this device must accept any interference received,
including interference that may cause undesired
operation.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures: