Kyosho MZN110 VeilSide S2000 Millenium ユーザーマニュアル
- タイプ
- ユーザーマニュアル
Receiver Antenna
Bend the receiver antenna as shown below.
< >
< Only for 27MHz >
Before beginning assembly, please read these instructions thoroughly.
MZN110-T01
R
THE FINEST RADIO CONTROL MODELS
INSTRUCTION SHEET
No.MZN110
90mm
Narrow
Tools : Must be prepared.
*Cutter Knife. *Nippers *Adhesive for plastic
*A Phillips Screwdriver
(Precision type or a small sized)
+ +
VeilSide S2000 Millennium
For MINI-Z Racer MR-03N RM Type / MR-015 RM Type
White Body Set (Non Decoration)
2
For painting. use plastic model paints.
Attach each part as required.
Painting should be done before assembling.
Rear Mount Type (RM Type)
2x5mm
Front body mount.
Chassis
Caution : Do not screw-in
excessively.
Wheelbase (M)
1
Preparation of Chassis
Assemble the chassis as shown below.
Motor mounting position
Adjustment of Wheelbase / Front Tread
Wind Shield
Body
Side Body Mount (L)
Side Body Mount (R)
2
2 x 5mm
TP Screw
Replace the front body mount
with the one included in the set.
Front Body Mount
TP
23.5mm
2x6mm
2mm
Receiver Antenna
Antenna Cord
Caution : Do not screw-in
excessively.
Body
Squeeze the chassis into
side body mounts.
Chassis
Insert front of chassis into
the front body mount holder.
Carefully spread the sides
of the body over the chassis.
Mount in orderly sequence.
65471003-1 PRINTED IN CHINA
046-229-4115
13001900
243-0034 153
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
www.kyosho.com
www.mini-z.jp
4
3
© Copyright 2010 KYOSHO CORPORATION /
R
Head Light Shield (R)
L
Head Light Shield (L)
R
Head Light Base (R)
L
Head Light Base (L)
High Mount Stop Lamp
Rear Wing
TP Screw
Tail Light Lens (Red)
Tail Light Lens
(Red)
2
TP
L
Tail Light (L)
R
Tail Light (R)
Tail Light Lens
The following wheel & tire are recommended.
No. Part Names
< Only for 27MHz >
< 27MHz >
Put the receiver antenna
through the hole.
-
1
-
2
Kyosho MZN110 VeilSide S2000 Millenium ユーザーマニュアル
- タイプ
- ユーザーマニュアル
他の言語で
関連論文
-
Kyosho MZN23 SKYLINE GT-R R32 ユーザーマニュアル
-
-
-
-
-
-
-
-
-