XBA-10iP
Stereo Headset
Operating Instructions
使用說明書
4-439-653-12(1)
Frequency response: 5 Hz – 25,000 Hz
Cord: 1.2 m cord, using PCOCC (Y-type)
Plug: Four-conductor gold-plated L-shaped stereo
mini plug for iPod with remote function
Mass: Approx. 3 g (without cord)
Microphone
Open circuit voltage level: – 42 dB (0 dB=1 V/Pa)
Supplied accessories
Hybrid silicone rubber earbuds: SS (red) (2), S (orange)
(2), MS (yellow) (2), M (green) (attached to the unit at
the factory) (2), ML (blue) (2), L (light blue) (2), LL
(purple) (2) / Noise isolation earbuds: S (orange) (2), M
(green) (2), L (light blue) (2) / Cord adjuster (winds
cord up to 50 cm) (1) / Clip (1) / Carrying pouch (1)
* IEC = International Electrotechnical Commission
** 150 mV input
Design and specifications are subject to change
without notice.
Optional replacement earbuds can be ordered from
your nearest Sony dealer.
About hybrid silicone rubber earbuds
Keep earbuds clean. To clean the earbuds, wash them
with a mild detergent solution.
Removing the headphones
After use, remove the headphones slowly.
Note
Headphones are designed to fit closely in your ears. If
the headphones are pressed hard while in use or taken
off too quickly, they may cause injury.
Wearing headphones may produce a diaphragm click
sound. This is not a malfunction.
English Stereo headset
Using the Centre button
Plays/pauses a track of the connected iPod product
with a single press. Skips to the next track with a
double press. Skips to the previous track with a triple
press. Starts the “VoiceOver*” feature with a long press
(if available).
Press once to answer the call. Press again to end. Hold
down for about two seconds to reject an incoming call.
When you let go, two low beeps confirm the call was
rejected.
* Availability of the “VoiceOver” feature depends on
iPod and its software version.
Note
Be careful not to unintentionally press any buttons
when you carry your iPod with this unit connected.
How to use / 使用方法 /
©2012 Sony Corporation
Printed in Thailand
Features
Balanced Armature driver unit
Micro-size Balanced Armature driver unit (full-
range) reproduces smooth and clear vocal sound.
High quality PCOCC cord
PCOCC cord to minimise sound transmission loss
and reproduce a clear high quality sound.
Double Layered Housing
Liquid Crystal Polymer inner housing and special
ABS outer housing reproduces clear, distortion-free
mid-high range.
Noise-Blocking design and various ear-bud sizes
Noise-Blocking design, with 10 sets of ear-buds to
choose from, for optimum attenuation of ambient
noise and minimum sound leakage.
Super-small body
Balanced Armature driver unit allows for a super
small body, and ultimate wearing comfort.
Serrated cord
Serrated cord and cord slider for tangle-free use.
Specifications
Headphones
Type: Closed, Balanced Armature
Driver unit: Balanced Armature
Power handling capacity: 100 mW (IEC*)
Impedance: 24 at 1 kHz
Sensitivity: 108 dB**
About noise isolation earbuds
Supplied noise isolation earbuds provide a snug fit for
effective attenuation of ambient noise.
Notes
Prolonged use of snugly fitting earbuds may strain
your ears. If you experience discomfort, discontinue
use.
The pressure-relieving urethane cushion is
extremely soft. If it breaks or detaches from the
earbuds, it will not take its correct position and the
earbuds will lose their noise isolation function.
The urethane cushion may deteriorate over time. If
the pressure-relieving power is lost and the
urethane cushion hardens, the earbuds may lose
their noise isolation function.
Do not wash the earbuds. Keep them dry, otherwise
they may deteriorate quickly.
Volume +*
音量 +*
Centre button
中央按鈕
Volume
音量 -
Microphone
⿆克⾵
* There is a tactile dot beside Volume +.
*
音量 + 旁有一個觸覺點。
Earbuds / 耳塞 /
Clip / 線夾 /
Precautions
High volume may affect your hearing.
For traffic safety, do not use while
driving or cycling.
Install the earbuds firmly. If an earbud
accidentally detaches and is left in your
ear, it may cause injury.
Do not leave the stereo headphones in a location
subject to direct sunlight, heat or moisture.
Note on static electricity
Static electricity accumulated in the body may cause
mild tingling in your ears.
To minimise the effect, wear clothes made from natural
materials.
Compatible iPod/iPhone/iPad models
You can use the unit with only the following models
supporting remote control. Update your iPod, iPhone
or iPad to the latest software before use. In the
Operating Instructions, iPod, iPhone and iPad are
collectively described as “iPod” except in special cases.
iPod touch (4th generation)
iPod touch (3rd generation)
iPod touch (2nd generation)
iPod nano (6th generation)
iPod nano (5th generation)
iPod nano (4th generation)
iPod classic 120GB 160GB (2009)
iPod shuffle (4th generation)
iPod shuffle (3rd generation)
iPhone 4S
iPhone 4
iPhone 3GS
iPad (3rd generation)
iPad 2
iPad
On copyright
iPad, iPhone, iPod, iPod classic, iPod nano, iPod
shuffle, and iPod touch are trademarks of Apple Inc.,
registered in the U.S. and other countries.
“Made for iPod,” “Made for iPhone,” and “Made for
iPad” mean that an electronic accessory has been
designed to connect specifically to iPod, iPhone or
iPad, respectively, and has been certified by the
developer to meet Apple performance standards.
Apple is not responsible for the operation of this
device or its compliance with safety and regulatory
standards.
Hybrid silicone rubber earbuds
混合矽膠耳塞
Noise isolation earbuds
噪音隔離耳塞
S M
Pressure-relieving
urethane cushion
氨基鉀酸酯釋壓泡棉
L
SS S MS M ML L LL