5
English
WARNING
Do not store or use the cord in a twisted state.
- Doing so may cause the wire in the cord to break with
the load, leading to electric shock or fi re due to a short
circuit.
Disconnect the plug by holding onto it instead of
pulling on the cord.
- Failure to do so may cause the wire in the cord to
break, and may cause burn, electric shock, or fi re due
to a short circuit.
Regularly clean the plug to prevent dust from
accumulating.
- Failure to do so may cause fi re due to insulation failure
caused by humidity.
Disconnect the plug and wipe with a dry cloth.
Always turn off the power switch and disconnect
the plug from the household outlet after use.
- Failure to do so may cause fi re or burn.
Use the household outlet alone: do not use with an
extension cord.
Fully insert the plug.
Always ensure the appliance is operated on an
electric power source matched to the rated voltage
indicated on the appliance.
- Failure to do so may cause fi re or electric shock.
When the appliance is used in a bathroom, unplug it
after use since the proximity of water presents a
hazard even when the appliance is switched off.
- Failure to do so may cause an accident or injury.
For additional protection, the installation of a
residual current device (RCD) having a rated
residual operating current not exceeding 30 mA is
advisable in the electrical circuit supplying the
bathroom. Ask your installer for advice.
- Failure to do so may cause an accident or injury.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent, or similarly
qualifi ed persons in order to avoid a hazard.
- Failure to do so may cause an accident or injury.
►In case of an abnormality or malfunction
Immediately stop using and remove the plug if there
is any abnormality or malfunction.
-
Failure to do so may cause fi re, electric shock, or injury.
<Abnormality or malfunction cases>
•Air is not emitted
•Unit stops sporadically
•Interior becomes red hot and smoke is emitted
- Immediately request inspection or repair at an
authorized service center.
►Maintenance
When you see sparks around the air outlet while
using the hot air setting, stop use and remove the
lint on the air outlet and air inlet.
- Failure to do so may cause burn or fi re.
►This appliance
Do not block or insert hair pins or other foreign
objects into the air inlet, air outlet, or nanoe™
outlet.
- Doing so may cause fi re, electric shock, or burn.
EH-NA32_ASIA.indb 5EH-NA32_ASIA.indb 5 28/9/2561 13:37:1128/9/2561 13:37:11