2. Roland
  3. FA-66
FA-66

Roland FA-66 取扱説明書

  • ローランドFA-66オーディオインターフェースのユーザーマニュアルの内容を理解しました。このマニュアルには、FA-66の接続方法、特にフェライトコアの取り付け方法について詳細に説明されています。電磁ノイズ対策や周辺機器接続時の注意点なども記載されているので、ご不明な点がございましたら、お気軽にご質問ください。
  • フェライトコアはどこに取り付けますか？
    周辺機器のケーブルが細い場合、どうすれば良いですか？
    フェライトコアを取り外しても良いですか？
*40670278- 03*
↔
1.
2.
3.
© 2005
Attaching the Ferrite Core
You must attach the ferrite core before using the FA-66.
If you use a 6-pin
↔
6-pin FireWire (IEEE 1394) cable to connect the FA-66 to your
computer, you must attach the included ferrite core.
This is for the purpose of preventing electromagnetic noise; do not remove it.
1.
Attach the ferrite core to the FireWire (IEEE 1394) cable.
* You must attach it near the plug.
2.
Press the halves together until they click shut.
3.
If you connect a peripheral device to the FA-66, you must also attach the included
ferrite core to the FireWire (IEEE 1394) cable that connects the peripheral device to
the FA-66.
* If the cable included with your peripheral is thin, the attached ferrite core may slide
along the cable. If so, use a band or adhesive tape to fasten the ferrite core in place.
One such band is included.
* Be careful not to pinch your fingers when attaching the ferrite core.
* Do not damage the cable by pinching it excessively with the ferrite core.
Copyright ©2005 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form
without the written permission of ROLAND CORPORATION.
Ferrite core
FireWire (IEEE 1394) cable
Band for fastening the core
FA-66
Peripheral
device
*40670278- 03*
/