*40782556-01*
Connecting the GK Cable
40782556 1PD
Copyright © 2007 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of
ROLAND CORPORATION.
©
VG-99
The parts shown below (ferrite core) are installed
on the included GK cable.
For connecting to the GK IN connector on the VG-
99, choose the plug by which the ferrite core is
being attached.
Attaching the Ferrite Core
If you purchase a new GK cable, it will not have a ferrite
core on its cable. To use a new GK cable with the VG-99,
you must first install ferrite cores.
1. Lift up the ferrite core’s tabs and open the
ferrite core.
2. Place the GK cable in the ferrite core so that
the core abuts the base of the cable’s plug.
3. Push the tabs until they close securely with
a snapping sound.
* Be careful not to pinch your fingers when attaching the
ferrite core.
1.
2.
3.
VG-99
GK IN connector
Guitar with GK-3 / GK-2A /
other GK-Compatible guitar
Ferrite core
-
1
