40670278 2PD
↔
1.
2.
3.
© 2005
Attaching the Ferrite Core
You must attach the ferrite core before using the FA-66.
If you use a 6-pin
↔
6-pin FireWire (IEEE 1394) cable to connect the FA-66 to
your computer, you must attach the included ferrite core.
This is for the purpose of preventing electromagnetic noise; do not remove it.
1.
Attach the ferrite core to the FireWire (IEEE 1394) cable.
* You must attach it near the plug.
2.
Press the halves together until they click shut.
3.
If you connect a peripheral device to the FA-66, you must also attach the
included ferrite core to the FireWire (IEEE 1394) cable that connects the
peripheral device to the FA-66.
* If the cable included with your peripheral is thin, the attached ferrite core may
slide along the cable. If so, use a band or adhesive tape to fasten the ferrite core in
place. One such band is included.
* Be careful not to pinch your fingers when attaching the ferrite core.
* Do not damage the cable by pinching it excessively with the ferrite core.
Copyright ©2005 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form
without the written permission of ROLAND CORPORATION.
Ferrite core
FireWire (IEEE 1394) cable
Band for fastening the core
FA-66
Peripheral
device
40670278 2PD
/